blxseries blx-218swa...card.m5 cab.b card.m6 cab.b card.m7 cab.b hz hz hz additional info 100 hz low...

BLXSERIES CARDIOID CONFIGURATIONS BLX-218SWA

Upload: others

Post on 12-Sep-2020

11 views

Category:

Documents

0 download

Report

Download

Embed Size (px):

TRANSCRIPT

BLXSERIES

CARDIOID CONFIGURATIONS

BLX-218SWA

CARDIOID CONFIGURATIONS

PRESET LIST From the buttons below the display on the cabinet’s back panel you are able to configure the Basic adjustment functions of the internal DSP. Depending on the model, you can find the following configurations: Note: You must apply the desired configuration in each one cabinet. This is done via the buttons located on the back panel of the cabinet and requires electrical power to work.

BLX-218SWA

CARDIOID CONFIGURATIONS

BLX-218SWA

CARDIOID CONFIGURATIONS

BLX-218SWA

CARDIOID CONFIGURATIONS

BLX-218SWA

CARDIOID CONFIGURATIONS

BLX-218SWA

CARDIOID CONFIGURATIONS

BLX-218SWA

CARDIOID CONFIGURATIONS

BLX-218SWA

CARDIOID CONFIGURATIONS

BLX-218SWA

CARDIOID CONFIGURATIONS

NOTES: - All measurements have been taken in the open air. - Measurements carried out in “Half Space”. - In a closed room the response can vary depending on distance between walls, ceiling etc. - The graphs are shown in relative dB measurements. - The polar responses are shown in dB SPL obtained from acoustic prediction.

FIR low pass Filter

Low Pass Filter Introduction

· 2 Page 26 € vs=[0.5sin(2000πt)+sin(4000πt)+1.5sin(6000πt)] The three spectral components are f1=1000 Hz f2=2000 Hz f3=3000 Hz (a) The gain of the band-pass filter is zero

Review Spatial Filters Smooth Blur – Low Pass Filter Sharpen – High Pass Filter Edge detection

EMLAB Chapter 8. Microwave Filters 1. EMLAB Common filter responses Low-pass filter High-pass filter Band-pass filter Band-reject filter Passive filter

Ultra-Wide-Band (UWB) Band-Pass-Filter Using Integrated ... · UWB Band-Pass-Filter Results for Flip-Chip IPD • Typical characteristics of the manufactured UWB band-pass-filter

High-Pass Filter. Low-Pass Filter. Band-Pass Filter. Band-Stop Filter. Finite Impulse Response Filter (FIR). Infinite Impulse Response Filter

Low Pass Filter Design

Questions on FiltersIs this a high pass filter, a band pass filter, a low pass filter or a band reject filter? Explain your answer. (4 points) 4. Given the following source input:

High Pass Filter Final

Analog Filter Synthesis - Auburn Universitywilambm/pap/2011/K10147_C026.pdf · Butterworth Low-Pass Filter •Chebyshev Low-Pass Filter • Inverse ... Low-Pass to Multiple Band-Pass

- Pattern RM602820 RoomMatch® RM286020 and ......Frequency Response (+/-3 dB)1 60 Hz - 16 kHz Frequency Range (-10 dB) 55 Hz - 16 kHz Recommended High-Pass Protection Filter 50 Hz