steps for preparing report data
DESCRIPTION
Steps for preparing report data. Primary data process through Workstation Identify & connect trajectories, fill the small gaps (TRANSCRIPT
Steps for preparing report data
1. Primary data process through Workstation
Identify & connect trajectories, fill the small gaps (<20 frames)
2. Advanced data process through BodyBuilder
Fill all gaps, smooth all trajectories
3. Model Calculation (Golem model)
Summary of the steps for the calculation of
biomechanical parameters using GOLEM model • Copy model parameter (*.mp), model
(*.mod) and marker (*.mkr) files into your folder. It is recommended that Golem.mp file should at least be renamed by using subject name.
• Open a static trial in BodyBuilder.• Go to Model->Subject Settings. Connect the
three files (*.mp, *.mod, *.mkr) to the static trial.
• Check the "Static" tick box in the upper right hand corner.
Summary of the steps for the calculation of
biomechanical parameters using GOLEM model • Go to Model->View Parameters. Enter
subject anthropometrical parameters such as leg length, etc.
• Go to Model->Run Model. You should see some extra trajectories appear in the space.
• Save the *.mp file (it is not necessary to save the *.c3d but you can). You will be prompted for each when you try to close the window.
• Open the dynamic trial.
Summary of the steps for the calculation of
biomechanical parameters using GOLEM model • Go to Model->Subject settings. Verify the
correct files are still selected.• Make sure that the "Static" box is not
ticked.• Go to Model->Run Model. Trajectories will
appear.• Save and take to Polygon for making an
electrical report.