sportident mtb enduro...biking is a mixture of arduous uphill, downhill and cross country sections....
TRANSCRIPT
-
SPORTident GmbH • Arnstadt • Germany • www.sportident.com • [email protected] 1 | 4
The most recent style of mountain
biking is a mixture of arduous uphill,
downhill and cross country sections.
These timed sections (stages) are
linked by less strenuous intermediate
sections. The winner of the race is the
one with the lowest accumulated time.
Using AIR+
Based on the Active Card the system
AIR+ supports the special requirements
of MTB Enduro. The contactless time
keeping allows a quick tracking and
evaluation of the race. To stop at the
beginning or the end of a stage is not
required.
SPORTident AIR+ additionally enables
time keeping and identification by
passing SPORTident stations config-
ured in a gate made. Gate mode con-
figuration features higher time accuracy
of up to 1/10 seconds. This configura-
tion is recommended to be used espe-
cially for START and FINISH.
Preparation
Each rider has to be equipped with a
SPORTident Active Card (SIAC) for
contactless timekeeping. With a spe-
cific bike holder this card will be mount-
ed at the bike (frame, handlebar or
headset).
Before starting the SIAC has to be
switched on. A successful time keeping
will not be possible if the SIAC is not
activated. The activation of the SIAC is
shown by a flashing green LED.
SI-stations in the AIR+-Configuration
have to be charged before application.
SPORTident AIR+ is a real time system.
SI-stations should be synchronised by
using a master clock shortly before
application.
SPORTident MTB Enduro
V1.1 – 29.01.2014
Mad East Challenge e.V.
Mad East Challenge e.V.
-
To illustrate the application of the AIR+
configuration to the competitors it is
recommended to set up a test course
with some control points in the event
centre. There, the athletes can test and
monitor the feedback signals of the
SIAC at different passing speeds.
Event execution
SIAC supports fast registration of
competitors to participate at a race.
The standard SPORTident procedure
C L E A R – C H E C K – S TA RT –
CONTROL(S) – FINISH remains when
SPORTident AIR+ is used.
During the race the SIAC stores the start
and finish times of the stages. The
successful registration of the check-
points is indicated by an obvious optical
and acoustic feedback signal.
The deactivation of the SIAC is done
with registering the finish time. Without
a finish record the device deactivates
itself 20 hours after having received last
record.
Evaluation of the results
After the finish, race data stored in
competitors SIAC have be read onto a
computer for event evaluation. SIAC
readout is possible at any time and not
depending on SIAC's activation. Op-
tionally, the data can be read out and
transmitted by radio. Therefore to
enable this, the checkpoints and the
finish line can be equipped with a GSM
modem. This allows to show the results
data in real time and to present them on
different media.
Mad East Challenge e.V.
Advantages for the organisers
Easy and rapid installation even in areas where access is difficult, less personnel expenses due to fewer course marshals required.
The riders bring the data to the finish line. It is not necessary to read out the data in the field.
Many possibilities of evaluating and showing the data (e.g. live results at the course, Internet).
The stations will work without an external power source (recharge-able battery is integrated).
The SIAC is compatible to the whole SPORTident system and can be used in any combination with our traditional equipment.
SPORTident GmbH • Arnstadt • Germany • www.sportident.com • [email protected] 2 | 4
SPORTident MTB Enduro
V1.1 – 29.01.2014
-
Adjustment of the stations BS11-BL at the height of the handle
bar
SPORTident GmbH • Arnstadt • Germany • www.sportident.com • [email protected] 3 | 4
SPORTident MTB Enduro
V1.1 – 29.01.2014
Fixing the SIAC at the bike frame with the Mounting holder
"bike" developed by SPORTident
Fixing the SIAC at the handlebar with the Mounting holder
"bike" developed by SPORTident
Finish line (BS11-BL at the height of the handle bar)
-
Product recommendation
CardsSIAC- Active Card for the participants
Control stationsBS11-BS blue- Checkpoints with an identification range up to 1.2 m
BSF7/8- CLEAR and CHECK the SIAC before START
Stations for the finish lineBS11-BL large- Set up of gate configuration possible
Read out stationBSM7-D-USB- To read out the SIAC onto the computer
OptionalPrintoutset- Direct printing of SIAC data without a computer
SPORTident-Modem SIGSMDN- live data transmission from checkpoints to a web server by using GSM
AccessoriesMounting holder "bike" for SIAC- To mount the SIAC at the bike frame, handlebar or headset
Magnet- To switch on and off the stations BS11-BS
Service/OFF-Card- Card to deactivate the stations BSF7 or BSF8
Example for a competition set (3 stages and approx. 20
competitors)
SPORTident GmbH • Arnstadt • Germany • www.sportident.com • [email protected] 4 | 4
SPORTident MTB Enduro
V1.1 – 29.01.2014
Example for an enduro race with 3 stages
Seite 1Seite 2Seite 3Seite 4