100 oz

80 oz

60 oz

40 oz

Items and Tools Needed

MIXING INSTRUCTIONS

1 Pro-ColorPack perPro-Stamp Bag

or Pro-Texture Bag

2 Pro-ColorPacks perPro-Surfacer Bag

or Pro-MicroTop Bag

or

Pro-Cast Bucket

For white base only

Proline Concrete Tools, Inc. 2560 Jason Court, Oceanside, CA 92056• 800-795-4750 • Ph • 760-758-2561 • fax

www.prolinestamps.com

Fiberglass

Mixing Instructions Coverage Instructions

48 inches

24 inches

2 “ D

epth

Multiply Width X Height X Depth then multiply X .085

Example: If the desired thickness is .5 inch with drop down edges also at .5 inch thickness.

52” X 28” X .5” = 728 cubic inches

728 X .085 = 61.88 Lbs of Pro-Cast

1 Cubic Inch of Pro-Cast = .085 LBSCoverage Measured in Cubic Inches. Find volume in cubic inches of desired casting and multiply by weight of Pro-Cast .085 to �nd weight of Pro-Cast needed.

48” D

24”R

2” D

epth

Hint: Use Google calculator to �nd area then multipy by thickness and weight / .085.

To �nd an area of a circle

Example @ .5” thick: 28 X 28 X 3.14 X .5 X .085 =104.62 Lbs / weight of Pro-Cast needed.

Pi X radius squared X thickness X .085

Hint: Devide Pro-cast, �berglass, Color Pack and water evenly by weight to avoid waste.

2 Proline Color Packs Fiberglass provided50 Lb bucket of Pro-Cast Pre-measured 80 oz clean water Preferred mixer Clean bucket

1) Add approximately 60 oz. of the 80 oz. of water pre-measured to an empty clean bucket.2) Open Pro-Cast and set aside bag of provided �berglass. Add approximately half of the Pro-Cast to the 60 oz. of water mix well.3) Add 2 Proline Color Pack, mix well.4) Slowly combine remaining Pro-Cast and water, mix until thuroughly blended.5) After completely mixed, slowly mix in �berglass until well dispersed. Avoid over mixing at this point, as to not break down �bers.6) If additional �ow ability is needed, add up to 20 oz. of water. Do not over water.