combricks system

10
System Combricks Introduction The system will allow you to do several activities: 1. PROFIBUS network sniffer displayed on a website. 2. PROFIBUS network sniffer Software based "Profitrace 2 for Combricks" installed at a computer. 3. Activation of FieldCare Asset Management Software through Combricks Commdtm: Configuration and Maintenance of devices. 1. PROFIBUS network sniffer displayed on a website Without installation of any software on computer you can receive information for each device PB DP and PA network installed:

Upload: others

Post on 17-Mar-2022

1 views

Category:

Documents


0 download

TRANSCRIPT

System Combricks

Introduction

The system will allow you to do several activities:

1. PROFIBUS network sniffer displayed on a website.

2. PROFIBUS network sniffer Software based "Profitrace 2 for Combricks" installed at a

computer.

3. Activation of FieldCare Asset Management Software through Combricks Commdtm:

Configuration and Maintenance of devices.

1. PROFIBUS network sniffer displayed on a website

Without installation of any software on computer you can receive information for each

device PB DP and PA network installed:

1.1 Statistic of communication parameters for each device

1.2. Existing devices on the network (this picture shows a device with address 26

where appears the number of his GSD, that device was faulty

1.3. If we like to know regarding address 26 which Tag Number has we can see this in the

same display

4.1. Level signals that are in good or fault condition through Oscilloscope PB DP Images

1.5. Level signals that are in good or fault condition through Oscilloscope PB PA Images

1.6. Bargraph Image about each PB DP instrument in PB DP Network

1.7. Bargraph Image about each PB PA instrument in PB DP Network

1.8. Amplitude measurement, Jitter and noise on any device Profibus PA

1.9. Networking events can be analyzed on a computer using software "Profitrace 2 for

Combricks"

1.10. Sending a message of device fault by email and / or log file

1.11. Relay activation signal to transmit information in a discrete mode to a main system

failure alerts. We can expand the types of alerts by additional Relays.

2. PROFIBUS Network sniffer Software based "Profitrace 2 for Combricks" installed at a

computer

2.1. You can check Network statistics

2.2. Be using the software to transfer the information of the network through OPC Protocol

that allows transmitting information by HMI and can be used to transmit alerts to a Pager

2.3. List of existing devices on the network

2.4. Tracking the dialogue between the Master (PLC) and the Slaves

3. Activation of FieldCare Asset Management Software through Combricks Commdtm:

Configuration and Maintenance of devices

Best regards, Tzvi Ben Yosef Process Solution Dept. Manager

Tel: +972-9-8357090 ext. 111 Mobile: +972-52-7070808 Fax: +972-9-8350619 E-mail: [email protected] Web: www.inst-ic.com