CNC PORTFOLIO

Paul May

This was a prototype part that I programmed using CAMWorks and ran in a HAAS VF-3 CNC Mill. Every aspect of this part, except for the part design, was handled by myself. This includes buying materials, programming G-code, setting up the mill, tooling, etc.

This was another test fixture to aid in the development of a project. I also programmed it using CAMWorks and ran it in a HAAS VF-3 CNC Mill.

Also programmed in CAMWorks, and run on a HAAS VF-3 CNC Mill, these two pieces fit together as a slip fit. When clamped together, they held a watertight seal under minimal pressure.

Once again programmed using CAMWorks and run in a HAAS VF-3 CNC Mill, I then placed these pieces into an oven where they were fused together without compromising the integrity of the channels.