automation interface module (aim) worksheet …page 5 automation interface module (aim) worksheet...
TRANSCRIPT
Page 5
Automation Interface Module (AIM) Worksheet
Communications Interface Module (CIM) Worksheet
Directions: Fill in section 1: Document the desired status and control points for each lighting panel. Please indicate the # of relays in each panel and
whether you would like to just check status or if you would also like to issue commands. If the panels have the same command and status requirements,
you may submit one sheet that has all applicable panels listed in the space provided at the bottom of this section. Fill in section 2 on one sheet only.
Section I Relay Outputs Local Contact Inputs
Relay
Check Relay Status
Issue Relay Commands
If you wish to issue commands to this relay as part of a command group, please indicate group #
that this relay belongs to. Notes Input
Check Input
Status Notes
01 01
02 02
03 03
04 04
05 05
06 06
07 07
08 08
09 09
10 10
11 11
12 12
13 13
14 14
15 15
16 16
17 17
18 18
19 19
20 20
21 21
22 22
23 23
24 24
25 25
26 26
27 27
28 28
29 29
30 30
31 31
32 32
33
34
35
Analog Input
Check Input
On/Off Status Check Analog Reading
36
37
38 01 39 02 40 03 41 04 42
43
44
45
46
47
48
Section II Setup Information (Fill in on one sheet only and choose only one protocol)
Automation Interface Module (AIM) Communications Interface Module (CIM)
What Protocol will you be using? (circle one) BACnet Modbus LON N2
BACnet
I will be using BACnet over IP I will be using BACnet over Ethernet (Please provide the following information for proper (Please provide the following information for proper configuration) configuration. Please note – the MAC address
information of the unit will be provided on the final
IP Address mapping table once the unit is configured)
Subnet Mask BACnet Network Number
Default Gateway IP Address Desired BACnet Device Object Instance ID#
Desired BACnet Device Object Instance ID#
I will be using BACnet over ARC156 I will be using BACnet over MS/TP (Please provide the following information for proper (Please provide the following information for proper configuration) configuration)
Desired ARCnet Address Desired MS/TP Address
BACnet Network Number BACnet Network Number
Desired BACnet Device Object Instance ID# Desired BACnet Device Object Instance ID#
What is the desired baud rate
What is the desired Max Master setting? (default is 127)
Modbus Choose Protocol Configuration: Baud Rate Data Bits Expected
Choose Protocol Configuration Baud Rate Data Bits Expected
RTU 1200 8
ACCII 2400 7
4800
Choose Com Type 9600 Stop Bits Expected
RS232 19200 1
2wire RS485 38400 2
4 wire RE485/422
Parity
Indicate Desired Slave Address Odd
Even
None
N2 What N2 slave address should be assigned to the AIM? (This address must be different from any other N2 device on the N2 BUS.)
LON No additional Information needed