warranty part replacement guide - led wire harness

WARRANTY PART REPLACEMENT GUIDE - LED WIRE HARNESS

MODEL

463341021463341221463341421463468021463468221463468421

XXXXXXXX • 03/11/21

NOTE: Some grill parts shown in the assembly steps may differ slightly in appearance from those on your particular grill model. However, the method of assembly remains the same.

CAUTIONRead and follow all safety statements, assembly instructions, and use and care directions before attempting to assemble and cook.

Some parts may contain sharp edges. Wear protective gloves if necessary.

PAGE 2

1

2 Disconnect / connect LED WIRE from battery box and LED switch.

Each step shows removal and replacement of parts. Follow the steps in order to remove parts, then reverse the steps to replace all parts.

Remove / replace DOOR ASSEMBLY.

1ST

2ND

PRESS

LED WIRE

LED WIRE

PAGE 3

4

3 Remove / replace WARMING RACK and CHEFS DELITE GRID/ TRAY.

CHEFS DELITE GRID/ TRAY

WARMING RACK

Remove / replace COOKING GRATES.

COOKING GRATE

PAGE 4

5

6

Remove / replace HEAT TENT.

HEAT TENT

Remove / replace all burner HITCH PINS, CARRYOVER TUBES and BURNER BRACES. Lift back end of burner up to disengage from valve and rest on back wall of firebox.VERY IMPORTANT: Burner tubes must reengage valve openings when replace burners.

CARRYOVER TUBE

HITCH PIN

Correct burner-to-valve engagement

1ST

2ND

BURNER

BURNER BRACE

PAGE 5

SIDEBURNER GRATE

7 Remove / replace SIDEBURNER GRATE.

8 Disconnect / connect side burner and main burner ELECTRODE WIRES. Remove / replace side burner VENTURI CLIP and WING SCREW. Remove / replace SIDE BURNER.

SIDEBURNER

VENTURI CLIP

SIDE BURNER ELEC-TRODE WIRE

MAIN BURNER ELECTRODE WIRE

PAGE 6

9

10

Remove / replace side burner side burner KNOB, BEZEL and VALVE.

Remove / replace ELECTRONIC IGNITION MODULE.

SIDEBURNER KNOB

SIDEBURNER VALVE

SIDEBURNER BEZEL

ELECTRONIC IGNITION MODULE

PAGE 7

11 Remove / replace SCREWS and WASHERS inside firebox.Remove / replace bottom two shelf mounting screws.Loosen / tighten two screws as shown. Lift shelf up and out to remove shelf. Both sides.

2ND

3RD

1ST

Loosen/ TightenLoosen/ Tighten

Remove / ReplaceRemove / Replace

PAGE 8

12 Remove / replace CONTROL PANEL.

CONTROL PANEL

13 Remove / replace LED WIRE HARNESS.

REVERSE THE STEPS TO ASSEMBLE THE GRILL.NOTE: READ THE USE AND CARE GUIDE IN INSTRUCTION MANUAL PRIOR TO LIGHTING THE GRILL.

LED WIRE HARNESS