warranty part replacement guide - led wire harness
TRANSCRIPT
WARRANTY PART REPLACEMENT GUIDE - LED WIRE HARNESS
MODEL
463341021463341221463341421463468021463468221463468421
XXXXXXXX • 03/11/21
NOTE: Some grill parts shown in the assembly steps may differ slightly in appearance from those on your particular grill model. However, the method of assembly remains the same.
CAUTIONRead and follow all safety statements, assembly instructions, and use and care directions before attempting to assemble and cook.
Some parts may contain sharp edges. Wear protective gloves if necessary.
PAGE 2
1
2 Disconnect / connect LED WIRE from battery box and LED switch.
Each step shows removal and replacement of parts. Follow the steps in order to remove parts, then reverse the steps to replace all parts.
Remove / replace DOOR ASSEMBLY.
1ST
2ND
PRESS
LED WIRE
LED WIRE
PAGE 3
4
3 Remove / replace WARMING RACK and CHEFS DELITE GRID/ TRAY.
CHEFS DELITE GRID/ TRAY
WARMING RACK
Remove / replace COOKING GRATES.
COOKING GRATE
PAGE 4
5
6
Remove / replace HEAT TENT.
HEAT TENT
Remove / replace all burner HITCH PINS, CARRYOVER TUBES and BURNER BRACES. Lift back end of burner up to disengage from valve and rest on back wall of firebox.VERY IMPORTANT: Burner tubes must reengage valve openings when replace burners.
CARRYOVER TUBE
HITCH PIN
Correct burner-to-valve engagement
1ST
2ND
BURNER
BURNER BRACE
PAGE 5
SIDEBURNER GRATE
7 Remove / replace SIDEBURNER GRATE.
8 Disconnect / connect side burner and main burner ELECTRODE WIRES. Remove / replace side burner VENTURI CLIP and WING SCREW. Remove / replace SIDE BURNER.
SIDEBURNER
VENTURI CLIP
SIDE BURNER ELEC-TRODE WIRE
MAIN BURNER ELECTRODE WIRE
PAGE 6
9
10
Remove / replace side burner side burner KNOB, BEZEL and VALVE.
Remove / replace ELECTRONIC IGNITION MODULE.
SIDEBURNER KNOB
SIDEBURNER VALVE
SIDEBURNER BEZEL
ELECTRONIC IGNITION MODULE
PAGE 7
11 Remove / replace SCREWS and WASHERS inside firebox.Remove / replace bottom two shelf mounting screws.Loosen / tighten two screws as shown. Lift shelf up and out to remove shelf. Both sides.
2ND
3RD
1ST
Loosen/ TightenLoosen/ Tighten
Remove / ReplaceRemove / Replace
PAGE 8
12 Remove / replace CONTROL PANEL.
CONTROL PANEL
13 Remove / replace LED WIRE HARNESS.
REVERSE THE STEPS TO ASSEMBLE THE GRILL.NOTE: READ THE USE AND CARE GUIDE IN INSTRUCTION MANUAL PRIOR TO LIGHTING THE GRILL.
LED WIRE HARNESS