Summary

I needed a home for my Ambient controller PCB for 3Dprinter enclosures.So I made this box.

https://www.youtube.com/watch?v=DbXVjOoNJw4

I had a few requirements :

Fit inside IKEA LACK table and not be higher then 1cm. Give me some 3Ddesign and print practice (don't go the easy way ;) Fit my PCB (of course)Have plenty holes to fit cables from different directions. Easy to tinker withthe whole setup for debugging and modding ( room to connect a usb cableand easy access to reset button. Have some kind of awesome factor thenjust a boring box.

Springs :

Can use both elastics/rubber bands (of 1mm diameter) or ballpoint springs(i stretched them a little bit to give the box a bit more oeuuhmf! But this isnot needed.)

Bolts : M3 (4x >=22mm, 12x 8mm) M2 (8x 5mm)

Want to build this whole project? I hope to try and make my firstinscrutable post, but for now this is what you need : 1x this box 2x Popupsensors : https://www.prusaprinters.org/prints/5140-pop-up-sensor-module-adafruit-sht31d-temperature-a 2x servo controlled aperture : https://www.prusaprinters.org/prints/5122-servo-automated-iris-aperture-for-air-flow-control 1x UI front panel : yet to upload 1x PCB with code ( I don'tknow yet how to share this, but give me a poke, I'm planning on making a

AcE Krystal

Ambient Control -PCB brain box

VIEW IN BROWSER

updated 17. 8. 2019 | published 17. 8. 2019

3D M

ODEL

ONLY

Model Files (.stl, .3mf, .obj, .amf) DOWNLOAD ALL FILES

157.2 KBupdated 17. 8. 2019

1.9 MBupdated 17. 8. 2019

147.1 KBupdated 17. 8. 2019

few ready to use PCB's to clone this project a few times. If your interested Imight have a few left over that I can sell. The code I will make opensourceand upload on github. If you really want I can also make a full set. Justmessage me and we might work something out ;)

3D Printers > 3D Printers - Upgrades

lifting mechanicalbox ambientcontrol cirquitbox pcbmount

brainbox arduinocase raisingbottom adafruitfeather

mechanicaltoy mechanical ikealack ikeaenclosure

enclosure box arduino adafruit

This remix is based on

Original Prusa i3 MK3 ENCLOSURE -Ikea Lack table -Prusa Research

by Dominik Císař

bottomframeanker.stl

lifting-bed.stl

clickerpin.stl

286.2 KBupdated 17. 8. 2019

483.2 KBupdated 17. 8. 2019

959.9 KBupdated 17. 8. 2019

2.0 MBupdated 17. 8. 2019

The Author has not uploaded any G-codes.Try to search in User G-codes section or generate and upload yourown.

License

This work is licensed under a Creative Commons (4.0 International License)

Attribution-ShareAlike

✖ | Sharing without ATTRIBUTION ✔ | Remix Culture allowed ✔ | Commercial Use ✔ | Free Cultural Works ✔ | Meets Open Definition

door.stl

spring-pole.stl

topboxflens.stl

box-frame.stl