tool box session ga tech safety and health consultation program

Tool Box Session

GA Tech Safety and Health Consultation Program

INTRODUCTION This training information has been prepared by the Safety and Health

Consultation Program at Georgia Tech with the technical collaboration of Mr. Juán C. Rodriguez and under the sponsorship of OSHA. Its content may be copied and distributed for free, and the only request made to the user is that Georgia Tech’s Safety and Health Consultation Program be acknowledged as the source. All information contained in this training is believed to be correct by the authors, but it is important to point out that, this is not an official OSHA publication and has not been revised or approved by OSHA. The user should be aware that the recommendations provided in this training do not replace any OSHA standard or regulation.

Georgia Tech Safety and Health Consultation ProgramGeorgia Tech Research Institute

260 14th Street, Fourth Floor

Atlanta, GA 30332-0837

Voice : (404) 407-7431

FAX : (404) 407-8275

Web http//www.oshainfo.gatech.edu Email: [email protected]


DefinitionsCave-in: means the separation of a mass of

soil or rock material from the side of an excavation, or the loss of soil from under a trench shield or support system. During a cave-in this material moves suddenly into the excavation, either by falling or sliding, in sufficient quantity to entrap, bury, or otherwise injure and immobilize a person


DefinitionsCompetent person: means a person who is

capable of identifying existing and predictable hazards in an excavation, or in the work practices of employees. If conditions are unsanitary, hazardous, or dangerous, the competent person has the authority to take prompt corrective measures to eliminate the hazards


DefinitionsExcavation: means any man-made cut,

cavity, trench, or depression in an earth surface, formed by earth removal

Trench: means a long and narrow excavation made below the surface of the ground. In general, the depth of a trench is greater than the width


Definitions

Stable Rock: means natural solid mineral material

Soil Types Type A: means cohesive soils; example: clay Type B: means soil with poor cohesion, example:

crushed rock / angular gravel/sandy soil Type C: means soil without cohesiveness, example:

gravel and sand


Acceptable visual and manual tests for soil classification

Observe the area adjacent to the excavation and the sides of the opened excavation for evidence of surface water, water seeping, utility pipes, or any other underground material such as tree roots

Determine if the soil is cohesive or notMake use of a pocket penetrometer, thumb

penetration, plasticity tests, soil’s hardness property, and any other strength test


Maximum allowable slope of an excavation vertical face

Slope requirements for excavations < 20 feet deep:

Stable Rock …. Vertical (90o)Type A……….. 3/4 : 1 (53o)Type B……….. 1 : 1 (45o)Type C……… 1 ½ : 1 (34o)


Protective Metallic Trench BoxThe intended use of a metal trench box is to

protect the workers from a cave-in or a similar incident

The designed purpose of timber shoring configurations and other systems of support are to keep the trench’s sides stable

The space between the excavation and the trench box must be as narrow as possible in order to avoid lateral movement of the trench box

GA Tech Safety and HealthConsultation Program

The soil from the excavation

Soil and any other excavated material shall be placed and kept at least 2 feet from the edge of excavations.

This is done to protect employees from materials (soil, loose rocks) or equipment that could pose a hazard by falling or rolling into the excavation, and also to keep an accurate measurement of the depth of an excavation


AccessTrenches more than 4 feet deep must have a

ladder or other means of of accessThe separation distance between ladders placed

in an excavation must not be more than 25 feetLadders shall be secured and the upper ends of

their side rails must extend at least 36 inches above the surface of the ground / edge of an excavation


Location of Underground UtilitiesKeep in mind that there might be underground

utility installations to be encountered during excavation work, such as sewer, telephone, fuel, electric, water lines, or any other underground installations.

In order to avoid damaging utility lines and as a personal safety measure, the estimated location of such lines must be determined prior to opening an excavation.

“Call Before You Dig” State Laws


tool box session ga tech safety and health consultation program

Documents

person ga tech safety

georgia tech safety

hazards ga tech safety

sand ga tech safety

width ga tech safety

strength test ga tech

georgia techs safety

definitions excavation