MA

GEN

TA C

IRCL

E M

ARK

S D

RIL

L H

OLE

SD

O N

OT

PRIN

T

SLIPPERS & GLOVES

MATERIALS Yarn: Two Top This!™ package including yarn and topperStitch marker and yarn needle.Using a US 8 (5mm) or Crochet Hook I (5.5mm)KNIT GAUGE: 4 sts = 1 inch; 8 rows = 1 inch in Garter StitchCROCHET GAUGE: 12 dc and 7 rnds = 4 inch x 4 inch (10cm x 10cm)

TM

TOP THIS!™ KNITTED SLIPPERS SIZES: Child (Adult). The finished size will be shorter than actual foot length. Slippers will stretch to fit.

INSTRUCTIONS: Leaving an 8 -10 inch tail, cast on 21 (29) sts.Work in Garter Stitch (knit every stitch, every row) until piece measures 5¼ (6½) inches UNSTRETCHED. To adjust for different foot lengths, work until piece measures 1¼ (2) inches shorter than the foot length from the back of the heel to the toe. Adult Size ONLYRS: (K1, K2tog) 4 times, K5, (K2tog, K1) 4 times. (21 sts)Next 3 rows: Knit all stitchesRS: (K1, K2tog) 3 times, K3, (K2tog, K1) 3 times. (15 sts)WS: Knit all stitches

Continue Adult; Begin Child Size here:RS: (K1, K2tog) 5 times (10 sts)WS: Knit all stitchesRS: (K2tog) 5 times (5 sts)WS: Knit all stitchesDraw yarn through the remaining 5 stitches and secure.

FINISHINGFold the piece in half selvedge to selvedge (edge to edge). With the extra yarn from the cast on, sew the cast on edges together to form the heel. With the yarn remaining at the toe, sew from the toe toward the heel, closing half the length of the slipper.Follow label instructions to secure character to the slipper as close to the halfway point as possible without the foam button showing.

TIP: To make slippers non-skid, add small dots of fabric paint to the bottom.

Please read all the instructions and the pattern carefully before starting to knit the design. Check your gauge – if less stitches or rows use smaller needles, if more use larger needles. IT IS ESSENTIAL TO WORK TO THE STATED GAUGE TO ENSURE SUCCESS.

MA

GEN

TA C

IRCL

E M

ARK

S D

RIL

L H

OLE

SD

O N

OT

PRIN

T

TM

SLIPPERS & GLOVES

TOP THIS!™ CHILD’S KNITTED FINGERLESS GLOVESFinished length: 6¼ inches. To adjust length, add or subtract stitches. Finished width: 5½ inches in circumference. To adjust sizing, add or subtract rows. The finished size should be about ½ inch narrower than the hand circumference at the point measured just above the crux of the thumb.

INSTRUCTIONS: Cast on 25 sts using a US 8 needle.Maintain stitch count and work in Garter Stitch (knit every stitch, every row) until piece measures 5½ inches. Bind off. Fold in half lengthwise, sew cast on to bind off edges together. Leave 3½ inches open at the end. Secure and weave in end.Working from the opposite end sew the edges together for 1¾ inches. Secure and weave in end. This will leave a thumb opening of 1 inch.Follow label instructions to secure character to the back of the hand area.

Finished length: 6 inches. To adjust length, add or subtract stitches. Finished width: 5½ inches in circumference. To adjust sizing, add or subtract rows. The finished size should be about ½ inch narrower than the hand circumference at the point measured just above the crux of the thumb.

INSTRUCTIONS: Leaving an 8 inches tail, ch 22.Row 1: Sc the second chain from the hook and the remainder of the sts in the row. (18 sts)Row 2 and all remaining rows: Ch 1, sc in the back loop of first and each subsequent stitch. (18 sts)Maintain stitch count and work until piece measures 5½ inches long or desired length. Fold in half lengthwise, ch 1 and slip stitch edge together through the back loop of the forward edge and the front loop of the rear edge. Leave 2¼ inches open at the end. Secure and weave in end.Using foundation chain tail, slip stitch opposite end together for 1½ inches. Secure and weave in end. This will leave a thumb opening of ¾ inch.Follow label instructions to secure character to the back of the hand area.

ABBREVIATION KEY:

TTYGLSL/25DMC CORP., 10 BASIN DR., SUITE 130, KEARNY, NJ 07032 All rights reserved worldwide © 2015 www.dmc-usa.com

cm - centimeterg st - garter stitchin - inchk - knitp - purlyo - yarn over

st(s) - stitch(es)BPdc: back post double crochetBPhdc: back post half double crochetch: chain

dc: double crochetFPdc: front post double crochetFPhdc: front post half double crochethdc: half double

crochetsc: single crochetKH: KeyholeRS: Right SideWS: Wrong Side

TOP THIS!™ CHILD’S CROCHET FINGERLESS GLOVESGauge: 3.5 sts = 1 inch in Single Crochet. Each rib ridge measures ½ inch. Each rib ridge is 2 rows.

Please read all the instructions and the pattern carefully before starting to knit the design. Check your gauge – if less stitches or rows use smaller needles, if more use larger needles. IT IS ESSENTIAL TO WORK TO THE STATED GAUGE TO ENSURE SUCCESS.