Component Checklist

2mm Allen Key (x1)

Step 1. Component Checklist

Check you have received all parts against the Component Checklist above.

Hardware

Mounting Fasteners

M4x10mm Screw (x4)

M4x12mm Screw (x4)

M4x16mm Screw (x4)

Wall MountAssembly (x1)

Step 2. Installing the Wall Mount Assembly (choose from one of the following options)

For mounting Spacedec to a Timber Stud Wall - Using the Wall Mount Assembly Bracket, markthe location of the 4 holes and drill using a 4mm drill bit. Secure the bracket to the wall using the M6 CoachScrews as shown in diagram A.

For mounting Spacedec to a Masonry Wall - Using the Wall Mount Assembly Bracket, markthe location of the 4 holes and drill using an 8mm masonry drill bit. Secure the bracket to the wall using the M6Coach Screws and Nylon Anchors as shown in diagram B.

Wall Mount AssemblyBracket

M6 CoachScrew

4 x 4mmHoles

Wall Material

Stud

Wall Mount AssemblyBracket

M6 Coach Screw

4 x 8mmHoles

Masonry Wall

Nylon Anchor

A. Timber Stud Wall B. Masonry Wall

Note: This product will suit VESA compliant displays with 100mm x 100mm (4”x 4”), 200mm x 100mm (8“x 4”) and 200mm x 200mm(4”x 4”) hole patterns only. It will support up to a maximum weight of 25kg (55lbs).

TH-2040-VTR

TOOLS REQUIRED:• Power Drill• Phillips Head Screw Driver• 4mm (3/16”) Drill Bit• 8mm (5/16”) Masonry Drill Bit• 8mm (5/16”) Socket Wrench or Shifter

SecurityScrew (x1)

M6 CoachScrews (x4)

TM

Flat Screen Wall Mount | Tilt

Installation Instructions

Tightening Tool

VESAplate (x1)

NylonAnchor (x4)

No portion of this document or any artwork contained herein should be reproduced in any way without the express written consent of Atdec Pty Ltd.Due to continuing product development, the manufacturer reserves the right to alter specifications without notice. Published: 30.10.09 ©

Installation Complete

Step 4. Attach your Display to the Wall Mount Assembly

Step 5. Adjust the VESA Ball Mount

Step 3. Attach the VESA plate to your Display

Position your Display to the desired viewing angle, using the 40°angular movement allowed by the VESA Ball Mount.

Depending on the weight of the display, it may be necessary to makeadjustments to the VESA Ball Mount. If the display does not hold its position, or is too resistant, adjust the Tension Plate located at therear of the VESA Ball Mount (see diagram right).

To make any adjustments, use the Tightening Tool supplied.

Check the display, and then adjust again if necessary.

TensionPlate

Tightening Tool

Loosen(-Kg)

Tighten(+Kg)

Insert the Security Screw supplied, andtighten using the 2mm Allen Key.

Push the bottom of the Display gentlyinto the VESA Ball Mount until youhear a ‘CLICK’.

SecurityScrew

2mmAllen Key

Hook the top of the VESA Plate ontothe VESA Ball Mount.

Back of Display

CLICK

There are three mounting hole configurations:• 100mm x 100mm (4”x 4”)

• 200mm x 100mm (8”x 4”)

• 200mm x 200mm (8”x 8”)

Choose appropriate Mounting Screwsfrom the Hardware supplied to suityour Display.

Back of Display Top ofDisplay

Mounting Screws (x4)

VESA plate

TIGHTEN