subli blockmarketing.xpres.co.uk/downloads/instruction-sheets/xp... · 2018. 10. 26. · achieve...
TRANSCRIPT
Phone:Web:E-mail:Support:
01332 855 [email protected]
Oakridge Park, Trent LaneCastle Donington, DerbyDE74 2PY
STEP BY STEP
Step 1
Step 2
Step 3
Step 4
Print your design on thesmooth matt side (Do not mirror image) Flock blade required.
Weed away any excess material. If using applicationtape cover with Transfer application tape using a squeegee to remove any air bubbles
Place transfer face up onto the garment (application tape on top) cover with a silicone sheet and press for 20 seconds at 150°C
Remove the silicone sheet cold or peel hot when using application tape
PLEASE NOTE: 500mm x 750mm samples are available free of charge upon request.
Uncoated garments only
Can be ironed inside out
Do not dry clean
Do not tumble dry
Up to 40°C inside out
CARE INFORMATION
TRANSFER SETTINGS
PRESSURE
PEEL
TEMPERATURE
TIME
Medium
Hot or Cold
20 seconds
150°C
Cotton
Polyester
Polyester/Cotton
SUITABLE FOR
PRODUCT INFORMATION
SIZE:
CUTTING FORCE:
APPLICATION TAPE:
50cm & 75cm wide x 20m rolls
FLOCK BLADE
Standard Tack Application tape
Hot or Cold190µ PVC
DURABILITY FINISH PEELMICRONS PU or PVC
®
Subli BlockXP3029 - 50cm wide x 20m roll
XP3035 - 75cm wide x 20m roll
Matt40°C
inside out
PLEASE NOTE: The sellers and manufacturers maximum obligation shall be to replace any product that has been proven to be defective. Neither the seller nor the manufacturer of Subli Block shall be liable for any injury direct or consequential, arising out of the use of, or inability to use this range. Subli Block has been tested using Kustom Kit garments, when applying to other garment brands results may vary, testing prior to purchase is recommended.
ADVISORIES
It is recommended to backweed Subli Block when looking to achieve small detail
Class 2
STORAGE: Store vertically in a dry room between 15-30 °C
Roland: From 65gf / Mimaki: From 55gf
ALL FORCE TESTING HAS BEEN UNDERTAKEN USING A NEW FLOCK BLADE ON A ROLAND SP300I AND A MIMAKI CJV150-75. THE FORCE WILL INCREASE WITH THE AGE OF THE BLADE, THEREFORE ALWAYS TEST PRIOR TO USE.
PRINT SETTINGS
Refer to ‘Textile TransferPrint Settings’ sheet.