smartmax with sdi12 ma-7020
TRANSCRIPT
-
7/27/2019 Smartmax With SDI12 MA-7020
1/2
SDI-12 Features
HSPA modem with SDI-12 inbuilt capability.
Supports up to 10 sensors with up to 10
measurements
Simple and Easy conguration using the web page
inside smartmax.
Congurable sensor numbering, measurement
numbering plus measurement names.
Data is stored in CSV format.
Congurable sampling rate.
Built in FTP client.
Scheduler to control uploading of SDI-12 data.
Supports storage of data up to 30 days.
*Not
toscale
CHOOSE WELL...CHOOSE WISELY...
CHOOSE MAXON...
SDI-12 is a simple ASCII-based protocol and communications standard, used by a multitude ofenvironmental measurement and monitoring equipment types, including rain gauges, water quality
sensors and pressure sensors.
The Smartmax with SDI-12 functionality is a high performance, self-contained, data logger suitable formeasuring a number of sensor types. This option coupled with the intelligence of the Smartmax wirelesscapabilities provides a low-cost alternative for an expensive RTU solution measuring a limited number
of sensors.
LOW COST RTU SOLUTION WITH THE SUPERIOR INTELLIGENCE OF THE SMARTMAXHSPA SMART MODEM WITH SDI-12.
-
7/27/2019 Smartmax With SDI12 MA-7020
2/2
www.maxon.com.au
Power
Data Logging
Water
Monitor
Metering
T | +612 8707 3000 F | +612 8707 3001 E | [email protected] 36A Gibson Avenue, Padstow NSW Australia 2211 www.maxon.com.au
A mini usb cable is required for rst time purchasers of the Smartmax, as most of the programming can only be done via the web interface. This is available in theSmartmax Complete Package (MA-2010C), the Smartmax SDK (MA-7000), and separately. Speak to your Maxon Account Manager for more information.
Data
HSPA: 5.76 Mbps UL, DL 7.2 Mbps (USB only)
WCDMA PS: UL 384 Kbps / DL 384 Kbps
WCDMA CS: UL 64 Kbps / DL 64 Kbps
GPRS/EDGE: UL 236 Kbps / DL 236 Kbps
GSM CS: UL 9.6 Kbps / DL 9.6 Kbps
Connections RS232 Connection
RS485 Connection
USB Connection
SIM Card Holder
I/O Port
External Power Connection (Molex)
Diagnostics
Antenna connector: FME male
LED Power Data
RX TX
Power DC Input Voltage Range: 7 to 34 VDC
Idle Current @ 12VDC: 45mA
Active Data Connection @ 12VDC: 150mA
Maximum Current @ 12VDC: 450mA
* Contact Maxon Australia for further information about Carrier Approvals.
Module Approvals GCF PTCRB
CE FCC
Carrier Approvals* ACA
General Features USB, RS232 and RS485 connection
Packet Data
2 Way SMS
Remote SMS diagnostics & reset
Embedded TCP/IP, UDP/IP STACK
In-built periodic reset
External DC Powered
Support VPN Server and Client Mode
Dynamic DNS
Supports DNP3 (Outstation) using extension I/O board
Rugged Metal Casing for industrial use
In-Built Web Interface
Programmable scheduler to control WAN connection
Telnet support
Save and restore modem conguration from a le
FOTA - Firmware upgrade over the air
External antenna connectivity to maximise HSPAcoverage
External LED to show Network and Connection status
Frequency Bands WCDMA/HSPA 850MHz, 900MHz, 1900MHz, 2100MHz
GSM/GPRS/EDGE 850MHz, 900MHz, 1800MHz and 1900MHz
SDI-12 Kit Includes SDI-12 Key, Installation Instructions & Certicate
SDI-12 Cable Interface (MA-4230)