Difficulty Rating: Beginner

Just KissesDesigned by Elise Lea for RKwww.robertkaufman.com

Featuring

SILVER MORNING FLIGHT

For questions about this pattern, please email Patterns@RobertKaufman.com.

Finished quilt measures: 64” x 76”

page 2

Fabric and Supplies Needed

WELM-19505-187 PLATINUM

WELM-19500-185 STEEL

WELM-19505-181 ONYX

WELM-19502-185 STEEL

WELM-19503-181 ONYX

WELM-19499-181 ONYX

WELM-19502-184 CHARCOAL

WELM-19503-186 SILVER

WELM-19500-160 TAUPE

Fabric amounts based on yardage that is 42” wide.

A F

B G

H

I

C

D

E

4-1/2 yards 1/2 yard

1/2 yard 1/3 yard

1/2 yard

1/2 yard

1/2 yard

1/2 yard

1/3 yard

5/8 yard

Copyright 2020, Robert KaufmanFor individual use only - Not for resale

You will also need:4 yards for backing

WELM-19503-160 TAUPE

Binding

Color ColorFabric FabricName/SKU Name/SKUYardage Yardage

- Read through all of the instructions before beginning.- All of the seam allowances are 1/4” unless otherwise noted.- Press seam allowances open unless otherwise noted. - Width of fabric (WOF) is equal to at least 42” wide.- Right sides together has been abbreviated to RST.- Remember to measure twice and cut once!

Notes Before You Begin

page 3

From Fabric A, cut:six 8-1/2” x WOF strips. Subcut: one 8-1/2” x 24-1/2” rectangle four 8-1/2” x 16-1/2” rectangles two 8-1/2” x 12-1/2” rectangles eight 8-1/2” squarestwenty-four 4-1/2” x WOF strips. Subcut: nine 4-1/2” x 8-1/2” rectangles one hundred thirty-two 4-1/2” squares Sew the remaining seven strips together, end-to-end, then subcut: two 4-1/2” x 68-1/2” side outer borders two 4-1/2” x 64-1/2” top/bottom outer borders

From each of Fabrics B-F and H, cut:three 4-1/2” x WOF strips. Subcut: nine 4-1/2” x 8-1/2” rectangles for the Flying Geese

From Fabric G, cut:two 4-1/2” x WOF strips. Subcut: seven 4-1/2” x 8-1/2” rectangles for the Flying Geese

From Fabric I, cut:two 4-1/2” x WOF strips. Subcut: five4-1/2”x8-1/2”rectanglesfortheFlyingGeese From the Binding Fabric, cut:eight 2-1/2” x WOF strips

Step 1: Place a 4-1/2” Fabric A square RST at one end of a Fabric B rectangle. Mark a diagonal line on the wrong side of the square, as shown. Sew on the marked line and trim away the excess fabric, leaving a 1/4” seam allowance. Press toward the triangle.

Cutting Instructions

Assemble the Flying Geese

Step 2:RepeatStep1attheremainingendoftherectangle.Theresultingflyinggeeseblockshould measure 4-1/2” x 8-1/2”.

page 4

Step 3: Repeat with all remaining Fabric B-I rectangles.

Step 4: Arrange the Flying Geese units and Fabric A squares and rectangles to form Column 1, as shown in the Quilt Assembly Diagram. Note the fabric placement and block orientation.

Step 5: Sew the units together to form the column. Press the seams down.

Step 6: Repeat Steps 4 and 5 to assemble Columns 2-7, sewing the units together to form the columns. Press the seams down in the odd numbered columns and up in the even numbered columns.

Step 7: Sew the columns together to form the quilt center. Press the seams open or to one side.

Assemble the Quilt

This pattern may be used for personal purposes only and may not be reproduced in any form without the express permission from Robert Kaufman Fabrics. This pattern is not for resale. All patterns, unless otherwise attributed, are © Robert Kaufman Co., Inc. 2005-2020. All rights reserved.

Step 8: Sew the side outer borders to the sides of the quilt center. Press toward the borders. Sew the top and bottom outer borders to the quilt center. Press toward the borders.

Your quilt top is complete! Baste, quilt, bind and enjoy!