rsv/rpv closed systems - beverage dispensing · dispense coupler - maintenance instructions....
TRANSCRIPT
![Page 1: RSV/RPV Closed Systems - Beverage Dispensing · Dispense Coupler - Maintenance Instructions. Created Date: 10/2/2013 8:50:33 AM](https://reader031.vdocuments.us/reader031/viewer/2022022801/5c70470409d3f2461d8c665c/html5/thumbnails/1.jpg)
01327-I1013 Copyright © 2013 Micro Matic USA, Inc. All Rights Reserved.
RSV/RPV Closed SystemsDispense Coupler - Maintenance Instructions
1 2 3
4 5
Remove dry break seal from probe and discard.
Remove insert and discard. Remove spring from probe and discard.
Remove main seal from coupler body and discard.
Disassemble coupler by removing c-clips and clevis pins in order to replace O-ring seal.Note: This step and steps 6 and 7 in disassembly and steps 1, 7 and 8 in assembly do not apply to couplers with rivets.
Disassembly
Probe
6 7
Separate probe assembly from coupler body.
Remove O-ring seal from coupler body and discard.
Insert
Spring
![Page 2: RSV/RPV Closed Systems - Beverage Dispensing · Dispense Coupler - Maintenance Instructions. Created Date: 10/2/2013 8:50:33 AM](https://reader031.vdocuments.us/reader031/viewer/2022022801/5c70470409d3f2461d8c665c/html5/thumbnails/2.jpg)
013267-I1013 Copyright © 2013 Micro Matic USA, Inc. All Rights Reserved.
1 2 3
DVC 2400 Viton Seal Kit. Install new O-ring seal into grove. Note: Lightly lubricate O-ring prior to installing with silicone grease or a lubricant that is compatible with the product. Take care not to spread the lubricant on other components.
Turn coupler body upside down.Clean main seal groove. Install new main seal.
Assembly
O-ring Main SealSpring Dry Break
Seal
InsertC - Clips
4 5
Install spring by placing the largest end of spring into the probe and wiggle in a clockwise direction while pressing down firmly.
Install new dry break seal on insert. Note: Seal must be secured over groove on insert for proper installation.
6
Place new dry break seal assembly on spring. Press the new dry break seal assembly firmly into the probe until the dry break seal locks into place.
Secured correctly
1 2
Secured correctly
Probe
7 8
Push probe assembly into coupler body. Slide lock arm into lock arm guide.
Place new dry break seal assembly on spring.
9
Lock armLock arm guide
Correctly assembled coupler.
RSV/RPV Closed SystemsDispense Coupler - Maintenance Instructions