rola roof rack w arnty reg is o c d · 2015. 7. 27. · a b 00mm 00mm your roof rack is at its...

2
Front RH LH (x) mm Equal = Equal = Equal = Equal = (x) mm End Support Distance and Bar length 27-0846 Rear RH 27-0844 Front RH 27-0847 Rear LH 27-0845 Front LH If specified to do so, fit the supplied Pad adaptors to the feet of each End Support in the location indicated. The numbers shown to the left correspond to the correct location of the feet pads. The numbers are moluded in the underside of each part. The numbers shown above in the vehicle table correspond to the correct adaptor block to be inserted in the foot pad (if required) Refer to step 1 of the fitting instructions for more information. Pad Adaptor Requirement (shown from the underside) Place Strap bolt facing up Place Strap bolt facing down The strap bolt Strap Bolt Position The strap bolt position is important to the correct set-up of your end supports. Refer to the vehicle specific image and follow the instructions for correct installation position. End suport distance from mid-pillar Distances for setting out your racks are defined from the mid pillar of the vehicle. Both forward and rearward measurements are given to the centre of the straps. Take care to set your racks out as shown to ensure your racks fit and perform as they have been design to. Right & Left hand sides of the vehicle are defined as you would be when sitting in the vehicle Front Mid pillar A B 00mm 00mm Your roof rack is at its strongest and looks its best when the cross bar is centred equally within the end supports. Measure the distance between end supports on the underside of the bar. Slide the end supports until the distance between them is correct and the cross bar is centred. Lock the bars in place using the locking lever and proceed to the next step. Installation Guide follow the vehicle specific instructions to set up your racks correctly Strap Bolt Position End Support Distance and Bar length (x) Pad Apaptors End Support Distance from Mid Pillar Concealed Extended Make Model Door/Body Series Released Finished Place strap bolt facing up Toyota Aurion 4D Sedan GSV50R 04/2012 on Front 875mm Rear 855mm Front 290mm Rear 370mm 27-0854 rear RH N/A 27-0855 rear LH N/A Front 7169 7170 Toyota Aurion 4D Sedan GSV40R 09/2006 03/2012 Place strap bolt facing up 27-0854 rear RH N/A 27-0855 rear LH N/A Toyota Camry 4D Sedan XV50R 12/2011 03/2015 Front 875mm Rear 855mm Front 290mm Rear 370mm Strap No. / Location Front 7169 7170 Toyota Camry 4D Sedan 40R 07/2006 11/2011 Place strap bolt facing up Front 7169 7170 Front 900mm Rear 890mm N/A N/A N/A N/A Front 280mm Rear 360mm Place strap bolt facing up Front 7169 7170 Front 900mm Rear 890mm N/A N/A N/A N/A Front 280mm Rear 360mm Toyota Camry 4D Sedan AVV50R 04/2015 on Place strap bolt facing up Front 7169 7170 Front 875mm Rear 855mm 27-0854 rear RH N/A 27-0855 rear LH N/A Front 290mm Rear 370mm Rola Roof Rack Warranty Registration Card To ensure smooth handling of any warranty claims, please complete the form below and send to the address indicated overleaf. Name Address Suburb Dealer/Reseller Suburb Vehicle Make Model/Year Product/Part Numbers Customer Details Store Details Vehicle/Product Details Please tick if you do not wish to receive product information or marketing offers from Rola.

Upload: others

Post on 05-Dec-2020

1 views

Category:

Documents


0 download

TRANSCRIPT

Page 1: Rola Roof Rack W arnty Reg is o C d · 2015. 7. 27. · A B 00mm 00mm Your roof rack is at its strongest and looks its best when the cross bar is centred equally within the end supports

Front

RHLH

(x) mm

Equal =

Equal =

Equal = Equal =

(x) mm

End Support Distance and Bar length

27-0846Rear RH

27-0844Front RH

27-0847Rear LH

27-0845Front LH

If speci�ed to do so, �t the supplied Pad adaptors to the feet of each End Support in the location indicated. The numbers shown to the left correspond to the correct location of the feet pads. The numbers are moluded in the underside of each part. The numbers shown above in the vehicle table correspond to the correct adaptor block to be inserted in the foot pad (if required)Refer to step 1 of the �tting instructions for more information.

Pad Adaptor Requirement(shown from the underside)

Place Strap bolt facing up

Place Strap bolt facing down

The strap bolt

Strap Bolt Position

The strap bolt position is important to the correct set-up of your end supports. Refer to the vehicle speci�c imageand follow the instructions for correct installation position.

End suport distance from mid-pillar Distances for setting out your racks arede�ned from the mid pillar of thevehicle. Both forward and rearwardmeasurements are given to the centre ofthe straps.Take care to set your racks outas shown to ensure your racks �t andperform as they have been design to.Right & Left hand sides of the vehicle arede�ned as you would be when sitting inthe vehicle

Front

Mid pillar

A B00mm 00mm

Your roof rack is at its strongest and looks its best when the cross bar is centred equally within the end supports. Measure the distance between end supports on the underside of the bar. Slide the end supports until the distance between them is correct and the cross bar is centred. Lock the bars in place using the locking lever and proceed to the next step.

Installation Guidefollow the vehicle speci�c instructions to set up your racks correctly

Strap Bolt Position

End Support Distanceand Bar length (x) Pad Apaptors

End Support Distance from Mid Pillar

Concealed

Extended

Make Model Door/Body Series Released Finished

Place strap bolt facing up

Toyota Aurion 4D Sedan GSV50R 04/2012 on Front 875mmRear 855mm

Front 290mmRear 370mm

27-0854rear RH

N/A

27-0855rear LH

N/A

Front

7169 7170

Toyota Aurion 4D Sedan GSV40R 09/2006 03/2012

Place strap bolt facing up 27-0854

rear RH N/A

27-0855rear LH

N/A

Toyota Camry 4D Sedan XV50R 12/2011 03/2015 Front 875mmRear 855mm

Front 290mmRear 370mm

Strap No. / Location

Front

7169 7170

Toyota Camry 4D Sedan 40R 07/2006 11/2011Place strap bolt facing up

Front

7169 7170

Front 900mmRear 890mm

N/AN/A

N/AN/A

Front 280mmRear 360mm

Place strap bolt facing up

Front

7169 7170

Front 900mmRear 890mm

N/AN/A

N/AN/A

Front 280mmRear 360mm

Toyota Camry 4D Sedan AVV50R 04/2015 onPlace strap bolt facing up Front

7169 7170Front 875mmRear 855mm

27-0854rear RH

N/A

27-0855rear LH

N/A

Front 290mmRear 370mm

Rola Roof Rack Warranty Registration CardTo ensure smooth handling of any warranty claims, please complete the form below and send to the address indicated overleaf.

Name

Address

Suburb

Dealer/Reseller

Suburb

Vehicle Make

Model/Year

Product/Part Numbers

Customer Details

Store Details

Vehicle/Product Details

Please tick if you do not wish to receive product information or marketing o�ersfrom Rola.

Page 2: Rola Roof Rack W arnty Reg is o C d · 2015. 7. 27. · A B 00mm 00mm Your roof rack is at its strongest and looks its best when the cross bar is centred equally within the end supports

Rola Roof Racks 5 Year Warranty

Rack System: (“Rola Roof Rack”). The Rola Roof Rack incorporates three components:

Cross Bars

End Supports

Fit Kit

VEHICLE COMPATIBILITY & WARRANTY

For more information visit www.rola.com.au

Cequent warrants that, subject to the exclusions and limitations below, the Rola Roof Rack will be free from defects in materials and workmanship for a period of 5 years commencing on the date of sale by the authorised Rola stockist to the original purchaser of the entire Rola Roof Rack, including the End Support, Fit Kit and Cross Bars.

If a defect appears in the Rola Roof Rack before the end of the warranty period and Cequent �nds the Rola Roof Rack to be defective in materials or workmanship, Cequent will, in its sole discretion, either:1. Repair the Rola Roof Rack or the defective component of the Rola Roof Rack free of charge;2. Replace the Rola Roof Rack or the defective component of the Rola Roof Rack; or3. Refund the purchase price of the Rola Roof Rack to the original purchaser.Cequent reserves the right to change the design, speci�cations or composition of the Rola Roof Rack without notice and without liability.

Cequent reserves the right to replace defective products or components with products or components of similar quality, grade and composition, where an identical product or component is not available.Goods presented for repair may be replaced by refurbished goods of the same type rather than being repaired. Refurbished parts may be used to repair the goods.

The 5 year warranty only applies where the entire Rola Roof Rack is purchased in one transaction and is installed and used together.

The 5 year warranty does not apply where:1. The Rola Roof Rack is not installed in compliance with the �tting instructions provided; 2. The Rola Roof Rack is not used as intended or designed; 3. Any part of the Rola Roof Rack, such as the End Supports, Fit Kits, or Cross Bars, is used with

other products or components notintended to be used in conjunction with the modular Rola Roof Rack system;4. The Rola Roof Rack has been on-sold or assigned by the original purchaser;5. The Rola Roof Rack has been modi�ed or repaired by someone other than Cequent or an authorised

Rola stockist;6. Cequent cannot establish any fault in the Rola Roof Rack after testing;7. The Rola Roof Rack has been subject to abnormal conditions, including �re, water, humidity,

pressure, stress or similar;8. The defect in the Rola Roof Rack has arisen due to abuse, misuse, neglect or accident;9. The defect in the Rola Roof Rack has arisen due to the unlawful or unusual operation of the vehicle to which it is �tted;10. The defect in the Rola Roof Rack has arisen due to the purchaser’s failure to properly assemble, install, �t, maintain or use the Rola Roof Rack in accordance with the speci�cations and instructions provided by Cequent.

For safety and use instructions, please refer to any General or Speci�c Fitting Instructions and Use & Care Instructions enclosed with the Rola Roof Rack or on our website at www.rola.com.au.

This warranty does not extend to fair wear and tear. Warranty claims can be made by contacting Cequent directly using the details below. A warranty claim must be accompanied by proof of purchase (such as receipt) and details of the alleged defect.It is the purchaser’s responsibility to arrange and pay for any warranty claims, including the shipment of goods to Cequent for inspection. The purchaser may seek reimbursement from Cequent for the costs of such activities, providing Cequent noti�es the purchaser in writing that a warranty claim is justi�ed. Any such claims must be made in writing via post or email. The bene�ts of this warranty are in addition to any rights and remedies imposed by Australian State and Federal legislation that cannot be excluded. Nothing in this warranty is to be interpreted as excluding, restricting or modifying any State or Federal legislation applicable to the supply of goods and services which cannot be so excluded, restricted or modi�ed.Our goods come with guarantees that cannot be excluded under the Australian Consumer Law. You are entitled to a replacement or refund for a major failure and for compensation for any other reasonably foreseeable loss or damage. You are also entitled to have the goods repaired or replaced if the goods fail to be of acceptable quality and the failure does not amount to a major failure. Cequent makes no express warranties or representations other than set out in this warranty.

Vehicle Compatibility GuideThis Fit Kit is compatible with the following vehicles.

Make Model Year

Toyota Camry 4D Sedan XV50R 12/11 - 03/15

IF YOUR VEHICLE IS NOT LISTED HERE

We are constantly adding vehicles to these kits, If the set-up instructions for your vehicle do not appear in

this guide, go to www.rola.com.au/�tkits/vcs010.pdf for your set up information

Toyota Aurion 4D Sedan GSV50R 04/12- on

Toyota Camry 4D Sedan AVV50R 04/15 - on

The repair or replacement of Rola Roof Racks or part there of, or a refund of the purchase price of the Rola Roof Rack, is the absolute limit of Cequent’s liability under this express warranty.Cequent, a division of TriMas Corporation Pty Ltd. 49 Paci�c Drive, Keysborough, VIC, 3173. Phone 1800 812 017. www.rola.com.au. For detailed warranty information visit us online.

Toyota Aurion 4D Sedan GSV40R 09/06 - 03/12

Please complete the Warranty form on the reverse side and post to:

PO BOX 4050Dandenong South

VIC 3164Australia

ABN 60 004 546 543

VFSO10Revision E

Toyota Camry 4D Sedan 40R 07/06 - 11/11