replace window in 1950
TRANSCRIPT
How to Replace the Windows in a 1950s Ranch-sty
Home Decoration magazine
Introduction
Homeowners looking to update or remodel theirhomes usually try to be loyal to the original design of thehome. While this is required in many areas for homes on ahistoric register, for most homeowners it's optional. It'spossible to stay true to the original design with modernmaterials and fixtures. No place is this more true than withwindows.
Introduction
Modern windows are much more energy efficient than those ofhalf a century ago. They also come in a wide array of sizes andstyles, so it is possible to have modern windows withoutcompromising on design. Ranch-style homes generally featurelarge, plate-glass windows, including picture windows; anassistant's help may come in handy installing the larger windows
What Things will you need?
• Caulking gun.• Caulking tools.• Square.• Measuring tape.• Screwdriver.• Hammer.• Replacement windows.• Gloves.• Assistant (optional).
Instructions
1. Remove the old windows and recycle them.
Instructions
2. Measure for the new windows. Measure inside the jamb from side to side and top to bottom.
Instructions
3. Clean the window jamb and repair any holes with putty. Lightly sand the filled holes after the putty dries.
Instructions
4. Prepare the new window. Check the fit of your new window by placing it into the opening. Move the window sashes to the center. Move the bumper stops to the center and find the mounting holes on the four sides.
Instructions
5. Caulk both sides of the window. Caulk the inside of the jamb's outside stops. Caulk and install the sill angle. Place the header on top of the window, screw into place and caulk.
Instructions
6. Install the new window. If necessary, tap in shims to ensure squareness. all corners must be square. Screw in mounting screws to the top and bottom. Adjust the header to eliminate any space between the window and frame then secure it with screws. While there is no trick to using shims, when necessary start at the nearest available point that is off-square. Light tapping should be all that is necessary to insert the shims.
Instructions
7. Check that the sashes move easily. Adjust as necessary. Caulk the inside of the windows and add the inside stops.
Thanks for visiting uswww.pouted.com