remesense final report effects of desensitizing agents on dentinal tubule occulsion 2 (1)
TRANSCRIPT
Finalreport
Effects of Desensitizing Agents on Dentinal Tubule Occlusion
Heinrich-Heine University University clinic Düsseldorf
Dental School Dept of Operative and Preventive Dentistry
Mooren Str. 5 40225 Düsseldorf, Germany
Düsseldorf, 20.02.2008 (Dr. Mozhgan Bizhang)
2
Effects of Desensitizing Agents on Dentinal Tubule Occlusion
Introduction Hypersensitive Dentine is a common chronic condition which affects a high
proportion of the adult population (8-35%) [1,2]. Dentine hypersensitivity can be
defined as a pain arising from exposed dentine typically in response to chemical,
thermal, tactile or osmotic stimuli, which cannot be explained as arising from any
other from of dental defect or pathology [3]. Although dentine hypersensitivity is
commonly encountered in dental clinics, no consistent treatment regimen has been
established.
The major problem regarding the development of dentin desensitizing agents is that
the mechanism of dentin sensitivity is not yet clearly understood [4]. The most widely
accepted hypothesis about how the stimuli influence nerve fibres is Brainstorm’s
hydrodynamic theory. This theory states that fluid within the dentinal tubules moves
in either an inward or outward direction when stimuli are applied. This stimulates the
nerve endings at the pulp/dentin interface, resulting in generation of pain impulses [5].
Various techniques and agents have been reported to be effective, e.g., potassium
oxalate [5], sodium fluoride [6,7], and strontium chloride [8], as well as resin liner [9]. One
of the aims of these treatments is to block the dentinal tubules in order to reduce the
flow of tubular fluid. If the hydrodynamic theory [10] of pain transmission is valid,
occlusion of patent dentinal tubules would be an effective means of treating dentin
hypersensitivity, since this treatment would reduce the fluid flow in the dentinal
tubules. Indeed, significant differences in the openings of dentinal tubules have been
reported between hypersensitive and naturally desensitized areas [11-13].
Currently, other methods of treatment have emerged such as oxlate solution, which
have been shown significant effectiveness in reducing dentin permeability and pain.
These agents precipitate calcium oxlate crystals that occlude patent exposed dentinal
tubules[5,14]. These crystals reduce dentine hypersensitivity.
The Aim of this study was to evaluate the ability of potassium oxalate on dentine
tubule occlusion and morphological tubule changes using scanning electron
microscopy.
3
Material and Methods Dentine discs from eight unerupted, caries-free, surgically extracted human third
molars were used for the study. The discs were prepared from the buccal surface (3
specimens from the lower and 3 specimens from the upper jaw) of the crown using a
trephine bur of 6 mm diameter. Each specimen was ground (2500-grit) flat on a
polishing machine (Exakt Appartebau, Norderstedt, Germany) to remove the enamel
and expose the underlying dentine in the cervical area.
The dentine discs were stored in distilled water containing 0.1% thymol. The removal
of enamel was confirmed by inspection of the specimens under a dissecting
microscope (8 x magnifications).
Specimens were treated with 0.5 mol/ L EDTA for 20 seconds to enlarge the dentinal
tubules. This process simulated the state of dentinal tubules in subjects with
hypersensitivity dentine. The specimens were then washed with distilled water and
used immediately for the experiments. Thereafter, impressions of the samples were
taken (Provil NOVO, Heraeus Kulzer, Hanau, Germany). The impressions were cast
with Epoxy resin (Araldite, Heidelberg, Germany).
Using an Applicator (99.9 g) Remesense (3% potassium oxalate, Remedent
Company, Deurle, Belgium) was applied on the specimens for 10 min as per the
manufacturers´ instructions. The specimens were then washed with distilled water
again. The casts were sputter coated (Cressington 108 auto, Cressington Scientific
Instruments Ltd, UK) after EDTA-treatment and the specimens after Remesense-
treatment. The dentine surface areas of casts with EDTA-treatment were evaluated
with a scanning electron microscope (SEM) (Hitachi S-3000N, Hitachi, Japan) under
one magnification (x1000) and the specimens with Remesense-Treatment under
three magnifications (x1000, x1800, and x4000).
Specimens were fractured with a sharp blade placed perpendicular to the buccal
surface. The occlusion of the dentinal tubules was evaluated by observing the
morphological changes of the precipitate in the dentinal tubules with a scanning
electron microscope (SEM) under three magnifications (x1000, x2500, and x4000).
Results A scanning electron micrograph of dentine with the EDTA treatment demonstrated
the typical appearance of opened dentine tubules. Those surfaces, from six different
4
dentine specimens (Diameter about 1-3 µm) were uniformly distributed over the
surfaces (Fig.1-6). The intertubular matrix and the walls of the tubules were free of
any debris or other irregular deposits. Treatment of EDTA surfaces with Remesense
(3% potasium Oxalate) from six different dentine specimens resulted in crystal
formation on the surface and a thin layer of the product could be seen over the
dentine, occluding the entrance of dentinal tubules (Fig.7-12). After splitting from six
different dentine specimens, the crystal formation could be seen extending into the
tubules (Fig.13-18).
5
Fig.2: SEM photomicrographs of a dentine surface with EDTA treatment, there are many tubule openings at the surface. (1000 x)
Fig. 1: SEM photomicrographs of a dentine surface with EDTA treatment, there are many tubule openings at the surface. (1000 x)
6
Fig.4: SEM photomicrographs of a dentine surface with EDTA treatment, there are many tubule openings at the surface. (1000 x)
Fig.3: SEM photomicrographs of a dentine surface with EDTA treatment, there are many tubule openings at the surface. (1000 x)
7
Fig.6: SEM photomicrographs of a dentine surface with EDTA treatment, there are many tubule openings at the surface. (1000 x)
Fig.5: SEM photomicrographs of a dentine surface with EDTA treatment, there are many tubule openings at the surface. (1000 x)
8
Fig.7: SEM photomicrographs of a dentine surface after Remesense treatment, there are many crystal-like inclusions at the surface. (1000 x)
Fig.8 SEM photomicrographs of a dentine surface after Remesense treatment, there are many crystal-like inclusions at the surface. (1000 x)
9
Fig.9: SEM photomicrographs of a dentine surface after Remesense treatment, there are many crystal-like inclusions at the surface. (1000 x)
Fig.10: SEM photomicrographs of a dentine surface after Remesense treatment, there are many crystal-like inclusions at the surface. (1000 x)
10
Fig.11: SEM photomicrographs of a dentine surface after Remesense treatment, there are many crystal-like inclusions at the surface. (1000 x)
Fig.12: SEM photomicrographs of a dentine surface after Remesense treatment, there are many crystal-like inclusions at the surface. (1000 x)
11
Fig.13: SEM photomicrograph of dentine after treatment with Remesense, There is a tin layer of the product on the dentine surface and the tubules are plugged below the surface, deeper into the dentine tubules. (1000 x)
Fig.14: SEM photomicrograph of dentine after treatment with Remesense, There is a tin layer of the product on the dentine surface and the tubules are plugged below the surface, deeper into the dentine tubules. (1000 x)
12
Fig.15: SEM photomicrograph of dentine after treatment with Remesense, There is a tin layer of the product on the dentine surface and the tubules are plugged below the surface, deeper into the dentine tubules. (1000 x)
Fig.16: SEM photomicrograph of dentine after treatment with Remesense, There is a tin layer of the product on the dentine surface and the tubules are plugged below the surface, deeper into the dentine tubules. (1000 x)
13
Fig.18: SEM photomicrograph of dentine after treatment with Remesense, There is a tin layer of the product on the dentine surface and the tubules are plugged below the surface, deeper into the dentine tubules. (1000 x)
Fig.17: SEM photomicrograph of dentine after treatment with Remesense, There is a tin layer of the product on the dentine surface and the tubules are plugged below the surface, deeper into the dentine tubules. (1000 x)
14
Discussion Dentine hypersensitivity is an exaggerated response to a sensory stimulus that
usually causes no response in a normal healthy tooth and is associated with dentine
exposure to the oral environment. Several different empirical treatments have been
used in the past to decrease or eliminate dentine hypersensitivity. However none of
them worked predictably.
Treatment with Remesense (3% potassium oxalate) has potential value as a
treatment for dentine hypersensitivity due to the fact that SEM photomicrographs of a
dentine surface after Remesense treatment show many crystal-like inclusions at the
surface of the dentine tubules. Furthermore those photographs show that the tubules
are stuffed below the surface with crystals proving that the product penetrates deep
into the dentine tubules. The general remark that one could make is that the depth of
the precipitate in the dentine tubules, measured from the dentinal surface, is
important from the point of sustenance of treatment, since daily brushing could easily
remove the precipitate if it was not deep enough or if it was precipitated only on the
dentinal surface. A deeper precipitate provides a greater surface area for mechanical
locking between the precipitate and dentinal tubules, which then makes the
precipitate difficult to remove from the dentinal tubules.
Conclusion Within the limitation of this in-vitro study, it was found that 3% potassium oxalate is
an effective treatment for dentine hypersensitivity. The result of this study confirmed
the results of the other studies with oxalate solution for the treatment of dentine
hypersensitivity[5,14].
.
15
References 1. Chabanski MB, Gillam DG, Bulman JS, Newman HN. Prevalence of cervical
dentine sensitivity in a population of patients referred to a specialist
Periodontology Department. J Clin Periodontol 1996; 23: 989-992.
2. Chabanski MB, Gillam DG, Bulman JS, Newman HN. Clinical evaluation of
cervical dentine sensitivity in a population of patients referred to a specialist
periodontology department: a pilot study. J Oral Rehabil 1997; 24: 666-672.
3. Addy M, Mostafa P, Absi E, Adams D. Cervical dentine hypersensitivity:
Aetiology and maagement with particular reference to dentifrices. 147. In
Rowe NH (ed): Proceedings of Symposium on Hypersensitive Dentine. Origin
and Management Edinburgh & London: E & S Livingstone Ltd,, 1985, 147.
4. Greenhill JD, Pashley DH. The effects of desensitizing agents on the hydraulic
conductance of human dentin in vitro. J Dent Res 1981; 60: 686-698.
5. Pashley DH. Dentin permeability, dentin sensitivity, and treatment through
tubule occlusion. J Endod 1986; 12: 465-474.
6. Minkov B, Marmari I, Gedalia I, Garfunkel A. The effectiveness of sodium
fluoride treatment with and without iontophoresis on the reduction of
hypersensitive dentin. J Periodontol 1975; 46: 246-249.
7. Pashley DH, Leibach JG, Horner JA. The effects of burnishing
NaF/kaolin/glycerin paste on dentin permeability. J Periodontol 1987; 58: 19-
23.
8. Kun L. [Biophsical study of dental tissues under the effect of a local strontium
application]. SSO Schweiz Monatsschr Zahnheilkd 1976; 86: 661-676.
9. Suda R, Andoh Y, Shionome M, Hasegawa K, Itoh K, Wakumoto S. Clinical
evaluation of the sedative effect of HEMA solution on the hypersensitivity of
dentin. Dent Mater J 1990; 9: 163-166.
10. Brannstrom M. The hydrodynamic theory of dentinal pain: sensation in
preparations, caries, and the dentinal crack syndrome. J Endod 1986; 12: 453-
457.
11. Absi EG, Addy M, Adams D. Dentine hypersensitivity. A study of the patency
of dentinal tubules in sensitive and non-sensitive cervical dentine. J Clin
Periodontol 1987; 14: 280-284.
16
12. Yoshiyama M, Masada J, Uchida A, Ishida H. Scanning electron microscopic
characterization of sensitive vs. insensitive human radicular dentin. J Dent Res
1989; 68: 1498-1502.
13. Yoshiyama M, Noiri Y, Ozaki K, Uchida A, Ishikawa Y, Ishida H. Transmission
electron microscopic characterization of hypersensitive human radicular
dentin. J Dent Res 1990; 69: 1293-1297.
14. Walters PA. Dentinal hypersensitivity: a review. J Contemp Dent Pract 2005;
6: 107-117.