programming an rotary encoder
TRANSCRIPT
No Sofware, No Apps, No Installations!
Learn How to Program your Encoder with the UBIFAST Configuration Tool
Program your Encoder in 8 Easy Steps!
Try it!Quick and
Easy!
Step 1Connect the Hardware
Power Device
Step 2Use a WiFi Enabled Device
Works with PC‘s, Tablet‘s and Smartphone‘s WiFi
Step 3Confi guration Instructions for Smart Phones
Connect to Wifi HotspotChoose POSITAL Confi guration Tool
at the network list
Open the WebbrowserGo to ubifast.fraba
Click Next and Start Confi guration
Step 4Confi gure Desired Incremental Parameters
Pulses Per Revolution (PPR)Any value between 1 and 16384 pulses
Incremental Pulse Direction„A before B“ or „B before A“
Incremental Output DriverPush-Pull (HTL) / 8 – 30 V Supply Voltage
RS422 (TTL) / 5 V Supply Voltage or
RS 422 (TTL) / 8–30 V Supply Voltage
Click Next
Step 5Enter Absolute Parameters
Singleturn Resolution 256 steps (8bit) to 65536 steps (16 bit)
Number of Turns 1 turn (singleturn) to
65536 turns (16 bit multiturn)
Code Binary or Gray Code Output
Preset Value 0 to maximum resolution
Click Next
Step 6Review Parameters
Verify the Incremental and Absolute parameters
Click „Confi gure“ to start programming the encoder
Step 7Your Confi guration was Successfull
Step 8Email Parameter to POSITAL for Future References