light touch switch - makers making change · 2019. 11. 18. · light touch switch assembly manual...
TRANSCRIPT
02.
07.
01.
03.
06.
04.
08.
Light Touch SwitchASSEMBLY MANUAL
Remove all the plastic support material and any residual plastic bits. Cut off the two leads on one side flush.
Cut off the two plastic mounting lugs completely flush.
05.
2cm
1.5cm
TWIST
1cm0 3cm2cmUse the wire stripper.
Hold the wire behind the switch and wrap the wire around the switch leads with a plier.
TWIST FRONT
BACK
PAGE 1 ORIGINAL DESIGN BY DAVROSS ON THINGIVERSE (#3211154)V1.1 | tiny.cc/LTswitch3
12.11.
13.
14.
Fill the indicated white rectangle with hot glue to seal in the cable. Do not overfill.
If wooden skewers are used, sanding it down slightly may help with the fit. 15. Hold the ink chamber or wooden skewer while
clipping to prevent it from flying away.
Light Touch SwitchASSEMBLY MANUAL
09. 10.
Add a small drop of hot glue. Do not add too much. Make sure the switch sitting flat and level.
Hold the switch in place and bend the wire to in between the two switch leads.
Solder the two leads indicated in the white rectangle.
PAGE 2 ORIGINAL DESIGN BY DAVROSS ON THINGIVERSE (#3211154)V1.1 | tiny.cc/LTswitch3