kinetic architecture eva van puyvelde presentaitie

18
KINETISCHE ARCHITECTUUR Ontwerpen 5A Studio Interieur Eva Van Puyvelde 2 MIRA 2013-2014

Upload: eva-van-puyvelde

Post on 23-Jun-2015

162 views

Category:

Technology


0 download

TRANSCRIPT

Page 1: Kinetic architecture eva van puyvelde presentaitie

KINETISCHE ARCHITECTUUROntwerpen 5A Studio Interieur

Eva Van Puyvelde 2 MIRA 2013-2014

?

Page 2: Kinetic architecture eva van puyvelde presentaitie
Page 3: Kinetic architecture eva van puyvelde presentaitie

Inspiration Sea organisms

Page 4: Kinetic architecture eva van puyvelde presentaitie

Inspiration Pneumatic structures

The Roof That Goes Up in Smoke | Overtreders W

Page 5: Kinetic architecture eva van puyvelde presentaitie

Inspiration Pneumatic structures

One Hundred and Eight | Nils Voelker

Page 6: Kinetic architecture eva van puyvelde presentaitie

Inspiration Pneumatic structures

Plastic Bag Installation | Robert Janson

Page 7: Kinetic architecture eva van puyvelde presentaitie

Inspiration Pneumatic structures

Cloud | Max Streicher Romulus & Remus | Max Streicher

Page 8: Kinetic architecture eva van puyvelde presentaitie

Design process

Emergent Surface | Hoberman’s joint venture with Buro Happold

My little piece of privacy | Niklas Globlow floor lamp | David Design

PHASE 1

PHASE 2

Page 9: Kinetic architecture eva van puyvelde presentaitie

Romulus & Remus | Max Streicher

PHASE 3

PHASE 4

breath in breath out

Page 10: Kinetic architecture eva van puyvelde presentaitie

Design process Materiality Research

old parachute (= nylon)plastic bags old curtain (=cotton fabric)

tyvek

Page 11: Kinetic architecture eva van puyvelde presentaitie

The tubes + surface arranged on the 6m long tyvek paper using the templates to draw the shap onto the fabric to be easily cut out with scissors afterwards

The arrangement of (31) tubes on the surface, trying to draw the attention to the touch sensor (one of te green circles).The one at the bottom is the inlet for the fan.

Selection of the different shapes. These templates were cut in fablab to easily draw the shape onto the fabricSelection of the type of tubes

Design process Selection of shapes, arrangement

Page 12: Kinetic architecture eva van puyvelde presentaitie

Construction process

Page 13: Kinetic architecture eva van puyvelde presentaitie

Location & set-up

touch sensor

the cable connecting the arduino board and the sensor leaves the box and reaches to the end of the tube where

the touch sensor is attached to a piece of red fabric.

Attachement

The tyvek canvas will be attached to the niche using tape, in order not to damage the existing structure

Power point

What’s behind the canvas?

a lamp to illuminate the structure, simultaneously with the breathing, revealing the nerves in the tyvek fabric

the fanthe arduino board+tinkerkit & tinkerkit modules

extension cables

Page 14: Kinetic architecture eva van puyvelde presentaitie

The system behaves like a living organism, there are three possible situations:

1 | The system will be ‘off’ when it is at ease and not disturbed or threatened by human beings

2 | When someone is less than 1 m away from the system, it will feel threatened/ agitated and start ‘breathing’

3 | When someone touches the end of the tube with the red end, it will defend itself by pretending to be dead --> ‘system off’

Concept

?

OFF ON

OFF

ON OFF

Page 15: Kinetic architecture eva van puyvelde presentaitie

Concept

Is someone at a distance < 1m?

JA NEE

‘breathe’ ‘system off’

Is someone touching the end of the tube with the touch sensor?

Initial state‘system off’

JA NEE

‘system off’ ‘breathe’

Page 16: Kinetic architecture eva van puyvelde presentaitie

Concept use of light to strenghten the breathing

Page 17: Kinetic architecture eva van puyvelde presentaitie

Images + movie

Page 18: Kinetic architecture eva van puyvelde presentaitie

link to movie: http://pixori.al/f05e0