Instructions for Collecting Pickleballs

Thank you for purchasing a Kollectaball! Our collectors work brilliantly with

Pickleballs however, it’s very important that they are assembled in a slightly

different manner to when collecting tennis balls.

The only difference is in the assembly of the wires; because Pickleballs are

lighter than most sports balls, it’s important you only assemble the cage with

half the wires. This will decrease the tension between the wires and allow the

Pickleballs to enter into the cage instead of being pushed further away when

collecting.

Please insert a wire in every other slot, as seen in the below pictures and

instructions. You will be left with 30 spare wires.

Step 1: Assemble

the handle as

explained in the

instructions that

come in the box.

Step 2: Insert a

wire in every other

slot. (Insert one

wire, miss a space

and then insert the

other).

Step 3: Continue

this until you have

completed the

sequence for the

first black plastic

disk.

If you make a mistake and place two wires side by side

as above, use the wire removal tool as shown. Push the

pin end of the tool into the hole corresponding with the

wire you would like to remove. Pull the wire out with

your spare hand.

Continue placing a wire in

every other hole until the

other black disk is

complete.

Take the other end of

the wires and begin

placing them into the

holes on the other black

plastic disk.

Take the orange cone and

place onto the available

screw

Use spanner provided to

tighten lock nut onto the

orange cone.

Lay down the rest the pieces on the

floor, you should have the handle, the

v-opener, the long screw, two flat

head screws, two washers and an M6

nut

Place the V-opener over

the handle so the holes

on either side of the v-

opener line up with the

holes on the handle

It should look like this

Placing a washer on either side,

thread the screw through the two

holes using the spanner provided.

It should now look like

this.

Now Screw the M6 nut

onto the end and tighten

Tighten the M6 nut with

the spanner provided.

Tighten the M6 nut with

the spanner provided.

*It’s worth retightening

both sides.

Push the bale into the

hole available at the end

of the handle.

Screw in the remaining

two flathead screws and

M6 nuts.

At the end of assembly you will be left with 30 wires. If you enjoy your

Kollectaball, please shout about us to your friends or on social media or review

our products on the sales channel you bought off!

Tighten the M6 nut with

the spanner provided.