Machine Assemble and Using Instruction1.Assemble tips:

There are three dupont line that connect the stepper motor and

the pcb. Two are the same length, another is shorter. The two

same length type is connected to the Y1 and Y2, the shorter type

is connected to the X .

2.This machine has the separate power switch, before starting

engraving, you need to turn it on( the blue button)

Benbox Firmware installing and Setting Instruction

1.Upgrade the firmware:(This machine support the Grbl and

Benbox, when you use Benbox, you need to upgrade the Benbox

firmware to the pcb, when you use the Grbl, you need to

upgrade the Grbl firmware to the PCB, the following show the

upgrade Benbox firmware steps, the Grbl’s same to the

benbox,but need to select the Grbl firmware when upgrade)

Then click the “√”, after show the “update firmware”, that means succeed.

2. Set the software parameter

After the above steps, you can use the

“Benbox” to control this machine now.