How to thread the Sewing Machine

Winding the BobbinPlace your thread on the

spool pinPull thread around knob on

opposite end of the machine

Thread bobbin up through the middle out one of the holes

Place bobbin on bobbin winder

Push knob in. (Machine needle will not operate when knob is pushed in).

It will automatically stop when it’s finished winding

Threading the Top ThreadThread it through the

tension.Then down through the

thread guideUp through the take up

lever.Make sure you pull the

thread behind the hook by the needle

The thread will make a capital “N”.

Make sure you thread all parts or it will not work Properly.

Threading the bobbimHold the open part of the bobbin

case toward you.Hold the bobbin so the thread

comes off in the clockwise direction.

Place the bobbin inside the bobbin case holding the end of the thread.

Pull the thread through the slit on the side and up into the hole.

Hold the bobbin by the string to see if the tension will balance the bobbin.

If the tension does not hold it, ask teacher for assistance.

Turn the open part of the bobbin case away from you.

Make sure the arm of the bobbin case is pointing up (toward the ceiling).

Look inside the machine and you can see where the arm will fit in.

Push it into placeIt is not complete until you here a

snap.Then you will turn the hand wheel

so the needle goes down once and back up.

This will grab the thread on the bottom and pull it up

Threading the bottom