Email: sales@taikonetwork.com www.taikonetwork.comCopyright © 2005 Taiko Network Communications Pte Ltd

AAGG11000000--1111 GGPPRRSS MM22MM TTeerrmmiinnaall –– MMooddbbuuss RRTTUU aanndd MMooddbbuuss IIOO

FFeeaattuurreess

AApppplliiccaattiioonnss

The AG1000-11 GPRS M2M Terminal is designed as a cost effective GPRS M2M Terminal . It can remotely monitors up to 8 dry contacts and control 4 relay outputs via Modbus RTU protocol over GPRS. It also support a RS232 port which allow user to connect to a Modbus RTU serial device.

There is a built-in microprocessor chip running on a real-time operating system. It takes immediate response to any change in both inputs and outputs condition. A GSM/GPRS modem is embedded in the gateway, user has to subscribe a SIM card for the gateway. The gateway can be installed in any location under GSM coverage.

The detailed functions provided and operation conditions were covered in the following sections of the manual.

• Tri-band GSM900/DCS1800/PCS1900

• Compact, high-performance and cost-effective

• Always on line

• Transparent transmission mode

• In built processor, protocol stack and software for automatic GPRS connection and forwarding

• Support point to point and host to multipoints

• Rugged, Industrial IP40 Enclosure

• 35mm Din Rail Mounting

• Support 1x RS232 and 8DI/4DO

• IO are mapped into ID254 modbus RTU address

GPRS M2M

INTERNET

GPRS NETWORK

DATA CENTER API

PLC IO

SERIAL DEVICE

POWER METER

Email: sales@taikonetwork.com www.taikonetwork.comCopyright © 2005 Taiko Network Communications Pte Ltd

SSppeecciiffiiccaattiioonnss

* Specifications subject to change without notice (Ver 1.0)

OOrrddeerr IInnffoorrmmaattiioonn

Model Description TNC-AG1000-11 GPRS M2M Terminal – Modbus and IO

Ethernet Connectivity :

• Speed: 10Base-T (RJ45 port)

Contact Rating :

• Inputs: 8x Dry contact inputs such as Relay Contact TTL signal

• Outputs: 4x Relay output as follows

at 230Vac/0.5A typical 3.0x105 operations at 6Vdc/0.1A typical 2.0x106 operations at 30Vdc/1A typical 5.0x105 operations at 30Vdc/2A typical 1.0x105 operations

GSM Standard :

• Antenna gain: 2.15dBi (JW-X-003) / 3dBi (JW-X-010)

• Bandwidth: Tri-band GSM900/DCS1800/PCS1900 MHz

Environment :

• Operating Temperature: 10慢 – 50慢 • Operation Humidity: 5% – 90% , Non-

condensing

Power Supply :

• Supply Voltage: 7V to 30VDC • Current drawn: 180mA (max) • Power consumption: 1.2Wdc at 12 VDC • Connection: Screw terminal

General Information :

• Size:130mm x 40mm x 120mm (D X W X H) • Weight: 460g • Diagnostic LEDs: GSM signal, TX and RX of

serial signal • Installation Method: 35mm Din-Rail, desk

mounts