engineering - brain products the software: insert the brain products ... engine ering engineering ...
TRANSCRIPT
engineering
Version 005 11/2015© Brain Products GmbH
Brain Products GmbH
Phone +49 (0) 8105 733 84 0
www.actichamp.com/forum
Installing the software: Insert the Brain Products Application Suite DVD and install the Recorder software as described in the User Manual. The User Manual can be found on the Application Suite DVD. Important: Leave the DVD in the drive while installing the hardware.
Installation CD-ROM
Connect the actiCHamp amplifier with the actiCHamp power cable to the actiPOWER.
top view
V002 12/2011
engineeringMode
engineering
engineeringMode
engineeringMode
engineering
engineering
www.brainproducts.com
Ch. 33-64
Ch. 65-96
Ch. 1-32
Ch. 33-64
Ch. 65-96
Ch. 97-128
Ch. 129-160
Ch. 1-32
engineering
Optional step: Insert the actiCHamp modules (PCI cards) to upgrade your system. Disconnect the actiCHamp completely before inserting modules.
www.brainproducts.com
For use with actiCHamp
only!
www.brainproducts.com
Trigger Out Trigger In
For use with actiPOWER
only!
back view
computer
back view
USB cable
www.brainproducts.com
Trigger Out Trigger In
For use with actiPOWER
only!
outgoing TTL pulses
incoming event markers
top view
29
10
2
11
4
engineering
engineering
engineering
engineering
engineering
Mode
V002 12/2011
engineeringMode
engineering
engineeringMode
engineeringMode
engineering
engineering
www.brainproducts.com
Ch. 33-64
Ch. 65-96
Ch. 1-32
Ch. 33-64
Ch. 65-96
Ch. 97-128
Ch. 129-160
Ch. 1-32
Connect the actiCHamp with the USB cable to your computer and install the amplifier driver.
Connect the active electrodes to the actiCHamp amplifier.
After use: Disconnect the actiPOWER from the actiCHamp and immediately recharge the actiPOWER. Leave the actiPOWER connected to the charger if not in use. The actiPOWER can be trickle charged and overcharging is not possible.
Connect the GND electrode to the actiCHamp amplifier.
engineering
001 02/2011www.brainproducts.com
GND
AUX 1
MY-Button
AUX 2 AUX 3 AUX 4 AUX 5 AUX 6 AUX 7 AUX 8
GND
front view
Note: To ensure correct and safe use of
the products, make sure that you read
the Operating Instructions on the DVD
carefully.
Installing the dongle: Plug in the USB dongle. The dongle driver is installed automatically. When installation is complete, the dongle will light up.
Important: Your computer must be equipped with at least two USB2 ports for the software license dongle and the actiCHamp amplifier.
professionalRECORDER
Set Up Your actiCHamp System
Version 005 11/2015© Brain Products GmbH
Brain Products GmbHZeppelinstrasse 7 82205 Gilching Germany
T +49 (0) 8105 733 84 0F +49 (0) 8105 733 84 505 [email protected]
Worldwide Caution:Our products are scientific equipment for
INVESTIGATIONAL USE ONLY! Medical use e.g. for diagnosis, treatment of disease or other
such purposes is strictly forbidden.