Download - Voting System-Report Inside
8/2/2019 Voting System-Report Inside
http://slidepdf.com/reader/full/voting-system-report-inside 1/14
Federal Institute of Science and Technology
1. Introduction
Department of ECE, FISAT Page number
8/2/2019 Voting System-Report Inside
http://slidepdf.com/reader/full/voting-system-report-inside 2/14
Federal Institute of Science and Technology
1. INTRODUCTION
India is world’s largest democracy. Fundamental right to vote or simply voting
in elections forms the basis of Indian democracy. In India all earlier elections a voter used to cast
his vote by using ballot paper. This is a longtime-consuming process and very much prone to
errors. This situation continued till election scene was completely changed by electronic voting
machine. No more ballot paper, ballot boxes, stamping,etc.all this condensed into a simple box
called ballot unit of the electronic voting machine. Cell phone based voting machine is capable of
saving considerable printing stationery and transport of large volumes of electoral material. It is
easy to transport, store, and maintain. It completely rules out the chance of invalid votes. Its use
results reduction of polling time, resulting in fewer problems in electoral preparations, law and
order, candidates' expenditure,etc. and easy and accurate counting without any mischief at the
counting centre. The aim of our project is to design & develop a mobile based voting machine. In
this project user can dial the specific number from any land line or mobile phone to cast his vote.
Once the user is connected to the voting machine he can enter his password & choice of vote. If he
has entered a valid choice & password his vote will be caste with two short duration beeps. For
invalid password/choice long beep will be generated. User is allotted 15 seconds to enter his
password & choice. A reset button is provided for resetting the system. A total key is provided to
display the result
Department of ECE, FISAT Page number
8/2/2019 Voting System-Report Inside
http://slidepdf.com/reader/full/voting-system-report-inside 3/14
Federal Institute of Science and Technology
(18 bold Italics – Right alignment) (Heading of Chapter)
2. Block Diagram
Department of ECE, FISAT Page number
8/2/2019 Voting System-Report Inside
http://slidepdf.com/reader/full/voting-system-report-inside 4/14
Federal Institute of Science and Technology
2. BLOCK DIAGRAM
Department of ECE, FISAT Page number
P
I
C
MI
C
R
O
C
O
N
T
R
O
LL
E
R
16x2
LCD
MODULE
GSM
MODEM
MOBILE
PHONE
POWER
SUPPLY
KEY
SWITCHES
8/2/2019 Voting System-Report Inside
http://slidepdf.com/reader/full/voting-system-report-inside 5/14
Federal Institute of Science and Technology
3. Block Diagram Explanation
Department of ECE, FISAT Page number
8/2/2019 Voting System-Report Inside
http://slidepdf.com/reader/full/voting-system-report-inside 6/14
Federal Institute of Science and Technology
3. BLOCK DIAGRAM DESCRIPTION
Block diagram consist of Pic microcontroller 16F877, Uart Max 232, Key
switches, 16x2 Lcd Module, Power supply, Gsm Modem, Mobile Phone.
3.1 Pic Microcontroller 16F877
Department of ECE, FISAT Page number
8/2/2019 Voting System-Report Inside
http://slidepdf.com/reader/full/voting-system-report-inside 7/14
Federal Institute of Science and Technology
Features
• Includes Powerful Microchip PIC16F877 Microcontroller with 8kb
Internal Flash Program Memory
• Operating Speed at 10MHz
• Direct In-Circuit Programming for Easy Program Updates
• Up to 28 I/O points with easy to connect standard headers
• RS232 Connection with MAX232
• Internal EEPROM
• 8 Channel 10-bit A/D Converter
• One 16-bit Timer with Two 8-bit Timers
• Power and Programming LED
• Reset Button
• Ideal as an Interchangeable Controller for Real-Time Systems
3.2 Lcd Module
LCD (Liquid Crystal Display) screen is an electronic display module and find a
wide range of applications. A 16x2 LCD display is very basic module and is very
commonly used in various devices and circuits. These modules are preferred
over seven segments and other multi segment LEDs. The reasons being: LCDs are
economical; easily programmable; have no limitation of displaying special &
even custom characters (unlike in seven segments), animations and so on.
A 16x2 LCD means it can display 16 characters per line and there are 2 such lines.
In this LCD each character is displayed in 5x7 pixel matrix. This LCD has two
registers, namely, Command and Data.
Department of ECE, FISAT Page number
8/2/2019 Voting System-Report Inside
http://slidepdf.com/reader/full/voting-system-report-inside 8/14
Federal Institute of Science and Technology
The command register stores the command instructions given to the LCD. A
command is an instruction given to LCD to do a predefined task like initializing it,
clearing its screen, setting the cursor position, controlling display etc. The data
register stores the data to be displayed on the LCD. The data is the ASCII value of
the character to be displayed on the LCD.
Features:
• 16 characters x 2 lines
• High-contrast super twist display
• LED Backlight
• Standard HD44780 operation
• Self-testing mode (pictured below) to check proper function and
jumper settings
• Power Requirement: 4.8 - 5.2 VDC approximate. 4 mA
• Size: 3.1" L x 1.4" W
• Weight: 0.1 lbs
Department of ECE, FISAT Page number
8/2/2019 Voting System-Report Inside
http://slidepdf.com/reader/full/voting-system-report-inside 9/14
Federal Institute of Science and Technology
Department of ECE, FISAT Page number
8/2/2019 Voting System-Report Inside
http://slidepdf.com/reader/full/voting-system-report-inside 10/14
Federal Institute of Science and Technology
2. TITLE OF CHAPTER (bold capital 14)
2.1 Enter the sub divisions as 2.1(12)
2.1.1 2.1.1
2.1.2
2.2 etc
All the figures, tables etc must be numbered.
The figure number and caption should appear below the figure.
The table number and caption should appear above the table.
Chapter 3 etc
Chapter N -1 (Results if any)
Chapter N CONCLUSION
References (In IEEE Format)
[1] W.Ding and B.Liu, “Rate control of MPEG video coding and
recording by rate quantization modeling”, IEEE trans.on circuits and systems for
video technology,vol.6,pp.12-20,Feb.1996
[2] --------------
All references to the above should be indicated as
( eg) According to Ding[1]
(Please refer IEEE transactions in the Library)
Appendix (Includes Data sheet, tables, programs, photographs etc if any)
Place a title page before every chapter.
The report shall be made with good quality bond paper.
Note: The format of the inner pages is attached…..
Department of ECE, FISAT Page number
8/2/2019 Voting System-Report Inside
http://slidepdf.com/reader/full/voting-system-report-inside 11/14
Federal Institute of Science and Technology
Matter (12 Times New Roman) with line spacing of 1.5
Margin left – 4 cm and 2 cm each at right, top and bottom
Paragraph alignment shall be left and right justified
6 pt spacing shall be given after headings and paragraphs.
1 cm indentation shall be given at the beginning of each paragraph except the first
paragraph of any section or chapter
Headings should be numbered and aligned left. Font sizes and styles must be as
given below
1 CHAPTER HEADINGS (0 LEVEL) 14pt, UPPER CASE, bold
1.1 Main Headings (first level) 12 pt, Title case, bold
1.1.1 Second level headings 12 pt, Sentence case, bold
1.1.1.1 Third level headings 12 pt, Sentence case, italics
Preparation of sketches should be done neatly with proper headings and details.
Care should be taken to see that SI units only are used in the illustrations.
Equations
All equations should be clearly set and numbered. Use equation editor as far as
possible and set the fond size to 12 points (which is the default fond size). When
referring to the equations in the text, preface the number with the word ‘Eq.’ Or
‘Eqs’ and place the number within brackets. Thus for example, Eq. (1.1).
Equations should be numbered as (1.1), (1.2), (1.3), etc. The first number represents the chapter number. The numbers should appear at the extreme right end
of the line. Do not set them in bold or italics type. Ensure that subscripts and
superscripts are clearly legible.
Department of ECE, FISAT Page number
8/2/2019 Voting System-Report Inside
http://slidepdf.com/reader/full/voting-system-report-inside 12/14
Federal Institute of Science and Technology
Tables
Tables must be set as the part of the text. Smaller fond sizes may be used to enable
the table to fit the space. All tables must have a caption. The caption should be
kept above the table and centered. If the caption runs in to more than one line ,
keep it justified at both ends. Caption should be numbered sequentially starting
with number 1. Thus for example , “ Table 1.1: Input data”. Leave 12 pt space
above and below tables. Large tables may be set in landscape , i.e. sideways on the
page, reading up.
Illustrations, Figures , Diagrams, Maps, etc.
These should be neat and clear. They should be positioned centrally on the width
of the page and close to their text reference. They should not appear on the opening page (first page) and must fit within the page text size. Try to avoid boxing text
between two illustrations on a page as this can sometimes make reading more
difficult. Ensure that all spelling and annotations (numbers, letters, symbols and
captions) confirm to their usage in the text.
Captions to figures, (diagrams and/or illustrations )should be set text size
and centered below the figure. All figures must be numbered sequentially starting
with the number 1. Thus for example, Figure 1.1: Thermocouple circuit. Leave 12
points above and below each figure/illustration.
Photographs
If you decide to include photographs use prints which are clear, glossy, have good
contrast. Paste them at appropriate positions.
References
A list of references must be included with every report and placed at the end.
References (In IEEE Format)
{[1] W.Ding and B.Liu, “Rate control of MPEG video coding and
recording by rate quantization modeling”, IEEE trans.on circuits and systems
for video technology,vol.6,pp.12-20,Feb.1996
[2] W. D. Doyle, “Magnetization reversal in films with biaxial anisotropy,”
in 1987 Proc. INTERMAG Conf., pp. 2.2-1–2.2-6.
Department of ECE, FISAT Page number
8/2/2019 Voting System-Report Inside
http://slidepdf.com/reader/full/voting-system-report-inside 13/14
Federal Institute of Science and Technology
All references to the above should be indicated as ( eg) According to Ding[1]
(Please refer IEEE transactions in the Library)}
Appendix (Includes Data sheet, tables, programs, photographs etc if any)
Department of ECE, FISAT Page number
8/2/2019 Voting System-Report Inside
http://slidepdf.com/reader/full/voting-system-report-inside 14/14
Federal Institute of Science and Technology
Department of ECE, FISAT Page
number