AUTOTRONIC CONTROLS CORPORATION • 1490 HENRY BRENNAN DR., EL PASO, TEXAS 79936 • (915) 857-5200 • FAX (915) 857-3344
MSD 6 HVC PROFESSIONAL RACING IGNITIONwith DEUTSCH CONNECTORS, PN 6601
IMPORTANT: Due to the MSD 6 HVC's Ignition's increased output, the MSD HVC Coil, PN 8250is the only coil that can be used with the PN 6600 Ignition.
Parts Included: 1 - 2-Pin Deutsch Wiring Harness1 - Ignition Control 1 - 1-Pin Weathertight Wiring Harness1 - 6-Pin Deutsch Wiring Harness 4 - Vibration Mounts
MOUNTINGThe Ignition can be mounted in any position and may be mounted in the engine compartmenthowever, it should be kept clear of direct engine heat sources. Use the Ignition as a template tomark the location of the mounting holes. Using 3/16" drill bit, remove the ignition and drill the holes.Install the vibration mounts and the ignition.
WIRINGFigure 1 shows the position, color and function of each wire. The following Figures show commonwiring schematics.
TriggeringThe MSD can be triggered by points, amplifier, or with a magnetic pickup.
Points: The single White wire of the MSD is for points triggering. It connects to the points/amplifieroutput wire of the distributor.
Magnetic Pickup: The Magnetic Pickup wires are in the 6-Pin connector. The Mag positive (+) wireis Violet, the Mag Negative(-) is Green. They are in the terminals marked "3" and "4".
Rev Control: The 4-Pin connector on the of the Ignition plugs directly into an MSD PN 8738 RevControl. This allows you to set a rev limit with plug-in modules.
ORANGE
BROWN
GREEN
VIOLET
RED
BLACK
(+) COIL
TACH
(-) MAG
(+) MAG
(+) 12V
(-) COIL
6
5
4
1
2
3
BLACK
RED
VIO
ORG
BROWN
GREEN
Figure 1 The Color, Function and Position of Each Wire.
IMPORTANT: Read instuctions thoroughly before attempting installation.
The MSD 6 HVC Professional Racing Ignition, PN 6601, is equipped with a new style Deutschconnector. As of 2/5/04, this connector is NOT approved for use in NASCAR competition. TheNASCAR approved connectors are installed on the MSD PN 6600 Ignition.
2 INSTALLATION INSTRUCTIONS
AUTOTRONIC CONTROLS CORPORATION • 1490 HENRY BRENNAN DR., EL PASO, TEXAS 79936 • (915) 857-5200 • FAX (915) 857-3344
POINTS/AMPLIFIERDISTRIBUTOR
WHITE
ORANGE/BLACK(+) (-) VIOLET/BLACK
MAGNETICPICKUPDISTRIBUTOR
BLACKORANGE
GREEN (M-)
VIOLET (M+)
TACHOMETER
BROWN
RED12V IGNITION SWITCH
BATTERY
OR+
PART NO.HVC
PN 8250
GROUND
TO REV CONTROLPN 8738
TO GROUND (-) HEAVY BLACK
TO BATTERY (+) HEAVY RED
PART NO.HVC
WHITE (NOT USED)
PART NO.HVC
TO BATTERY (+) HEAVY RED
TO GROUND (-) HEAVY BLACK
GROUND
+
BROWNTO TACH*
RED
RED
SPDT SWITCHPN 8807
DISTRIBUTOR
TOIGNITIONSWITCH
VIO
LET
GR
EEN
GREEN MAG (-)
VIOLET MAG (+)BROWNTO TACH*
ORANGE(+)
ORANGE(+)
GROUND
BLACK (-)
* TO SWITCH TACH SIGNALS, MSD OFFERS A TACH SPLITTER, PN 8911
PN 8250
P/N
880
7
TO 12 VOLTS
TO REV CONTROLPN 8738
TO REV CONTROLPN 8738
WHITE (NOT USED)
TO BATTERY (+) HEAVY RED
TO GROUND (-) HEAVY BLACK
BLACK (-)
GREEN MAG (-)
VIOLET MAG (+)
Figure 2 General Installation.
Figure 3 Dual Ignitions and Coils with a Dual Pickup Distributor.
INSTALLATION INSTRUCTIONS 3
AUTOTRONIC CONTROLS CORPORATION • 1490 HENRY BRENNAN DR., EL PASO, TEXAS 79936 • (915) 857-5200 • FAX (915) 857-3344
PART NO.HVC
PART NO.HVC
GROUNDBROWNTO TACH *
RED
RED
DISTRIBUTORVIO
LET
GREEN
VIOLET
GREEN MAG (-)
VIOLET MAG (+)BROWNTO TACH*
ORANGE (+)
ORANGE(+)
GROUND
BLACK (-)
BLACK (-)
* TO SWITCH TACH SIGNALS, MSD OFFERS A TACH SPLITTER, PN 8911
PN 8250
SPDT SWITCHPN 8807
TOIGNITIONSWITCH
P/N
880
7
TO 12 VOLTS
WHITE TO REV CONTROLPN 8738
WHITE TO REV CONTROLPN 8738
TO BATTERY (+) HEAVY RED
TO GROUND (-) HEAVY BLACK
TO BATTERY (+) HEAVY RED
TO GROUND (-) HEAVY BLACK
Figure 4 Dual Ignitions and Coils with a Single Pickup Distributor.
Figure 5 Complete Wiring with Tach Splitter and Alternate Action Switch.
PART NO. HVC
RED
+ORANGE(+) BLACK (-)
OPTIONAL
INDICATORLIGHT
(Light “On”when ignition is disabled) BATTERY
GP15KDIODES
BLACK WHITE
TO ENGINEOR
CHASSISGROUND
IGNITION DISABLEN.O. POSITION
PART NO.HVC
RED
ORANGE(+)
BROWN
GREEN (M-)
VIOLET (M+)
12 VOLTS
P/N 8807
TACHOMETER
GROUND+
BLACK(-)
BROWN
ALT. ACTIONSWITCHPN 8812
BROWN
TACHSPLITTER
PN 8911
PN 8250
PN 8250
WHITE
TO REV CONTROLPN 8738
TO REV CONTROLPN 8738
TO BATTERY (+) HEAVY RED
TO GROUND (-) HEAVY BLACK
GR
EEN
MA
G (-)
VIO
LET
MA
G (+)
TO BATTERY (+) HEAVY RED
TO GROUND (-) HEAVY BLACK
Note: The MSD Alternate Action Switch is designed to to be used in conjuction withNASCAR's amendment rule reguarding an auxiliary ignition On/Off button, 20-6.6.The MSD Switch can be used in either a Normally Open or Normally Closed position.
AUTOTRONIC CONTROLS CORPORATION • 1490 HENRY BRENNAN DR., EL PASO, TEXAS 79936 • (915) 857-5200 • FAX (915) 857-3344FRM25516 Created 02/04 Printed In U.S.A.
Limited WarrantyAutotronic Controls Corporation warrants MSD Ignition products to be free from defects in material
and workmanship under normal use and if properly installed for a period of one year from date of purchase.If found to be defective as mentioned above, it will be replaced or repaired if returned prepaid along withproof of date of purchase. This shall constitute the sole remedy of the purchaser and the sole liability ofAutotronic Controls Corporation. To the extent permitted by law, the foregoing is exclusive and in lieu ofall other warranties or representations whether expressed or implied, including any implied warranty ofmerchantability or fitness. In no event shall Autotronic Controls Corporation be liable for special orconsequential damages.
Service
In case of malfunction, this MSD component will be repaired free of charge according to the terms of thewarranty. When returning MSD components for service, Proof of Purchase must be supplied for warrantyverification. After the warranty period has expired, repair service is charged based on a minimum andmaximum charge.
Send the unit prepaid with proof of purchase to the attention of: Customer Service Department,Autotronic Controls Corporation, 12120 Esther Lama, Suite 114, El Paso, Texas 79936.
When returning the unit for repair, leave all wires at the length in which you have them installed. Be sureto include a detailed account of any problems experienced, and what components and accessories areinstalled on the vehicle.
The repaired unit will be returned as soon as possible after receipt, COD for any charges. (Groundshipping is covered by warranty). All units are returned regular UPS unless otherwise noted. For moreinformation, call the MSD Customer Service Line (915) 855-7123. MSD technicians are available from 8:00a.m. to 5:00 p.m. Monday - Friday (Mountain Time).
NOTES