Download - FCOA
-
8/4/2019 FCOA
1/31
-
8/4/2019 FCOA
2/31
Installation
-
8/4/2019 FCOA
3/31
Module Installation
Installation of guide Plates
-
8/4/2019 FCOA
4/31
222 Configuration Setting
-
8/4/2019 FCOA
5/31
Roxtec
Roxtec Position
-
8/4/2019 FCOA
6/31
Installation of BUS,RF and Power cables
-
8/4/2019 FCOA
7/31
External cable routing from Bottom
-
8/4/2019 FCOA
8/31
External cable routing from TOP
-
8/4/2019 FCOA
9/31
Cabinet Power Up and cable routing
-
8/4/2019 FCOA
10/31
Module for BTS common functionalities and internal/external connections
Supports up to 6 DTRX modules (up to 12TRX)
5 main functions of the module:
BTS O&M: SW downloading and storing (2 * BTS SW), configuration management, referenceclock and alarms
BTS integrated transport: Abis transmission
BB switching: communication between modules via Ethernet switch
BTS power distribution: single point for power intake and power distribution to all modules
BTS internal and external synchronization
PDU (powerdistribution unit)48V intake
Interchangeable Transport module:8xE1, 8xE1/T1 or 2x Flexbus
Site support system, MIBBUalarms (6), Aux equipment Q1,Local Management Port (LMP)
6x Ethernet to DTRX or RTC
PDU (power distribution unit)6x48V to other modules
Nokia Flexi EDGE System Module (ESMA, 3HU)
Out
1xEAC (ExternalAlarm & Control)12x alarm
inputs+6x controloutputs
HU = 44.4 mm
InSynchronization
-
8/4/2019 FCOA
11/31
Nokia Flexi EDGE Dual Duplexer Module (ERxA, 1HU) Dual duplexer (DDU) module together with Dual TRX create a logical Sector
module
Min 1 DDU per sector is needed
DDU is attached to DTRX module DDU provides
duplex functionality to combine TX and RX signals to same antenna feeder multicoupling 2 antenna connections (for 1 or 2 sectors) 2 TX inputs and 4+4 RX outputs (4 RX from antenna 1 and 4 RX from antenna 2)
DDU contains
2 duplex filter 2 Low Noise Amplifiers (LNAs) with high/low gain support for RX signal 2 Bias-Ts with VSWR measurement functionality
TRX loop is controlled through the DDU
Common TRX loop for all TRXs in same sector Loop can be performed from either TX to any of 8 RX outputs (only 1 TX and 1 RX can be
simultaneously tested)
4xRX 1 TX 2TX 1 RX forexternal BTS
RX forexternal BTS
HU = 44.
Ant 1 Ant 24xRX 2
-
8/4/2019 FCOA
12/31
Nokia Flexi EDGE Dual TRX Module (EXxA, 2HU)
Dual TRX module (DTRX) is a 2 carrier TRX unit, used as: a stand alone TRX module (2 TRX capacity) or a Sector module with the Dual duplexer module (2 TRX capacity) or as Double Power TRX, DPTRX (1 TRX capacity) or for Intelligent Downlink Diversity, IDD (1 TRX capacity)
DTRX consists of: BB part that is common to both TRXs RF part with 2 independent transmit (TX) chains and 4 receive (RX) chains
0-2 Wideband combiner (WBC) sub-modules RX connections for diversity: 2-way diversity: 2 RX inputs/DTRX used when both TRXs are in same sector
4 RX inputs/DTRX used when TRXs of the DTRX are in 2 different sectors 4-way diversity: 4 RX inputs/DTRX used (supported only with SRC or DPTRX)
DTRX connected to system module via single Gigabit Ethernet interface Power feed from system module via single cable
4xRX TX 2
0-2xWideband combiners
1xBus
1xDTRX-DDU 1xPowerPhase feedback from WBC (DPTRX)
TX 1
HU = 44.4 mm
-
8/4/2019 FCOA
13/31
FCOA Commissioning
-
8/4/2019 FCOA
14/31
IP Setting for connecting with FCOA
-
8/4/2019 FCOA
15/31
Commissioning manually or by SCF file
-
8/4/2019 FCOA
16/31
Site Specific Information
-
8/4/2019 FCOA
17/31
Manual Hardware Configuration
-
8/4/2019 FCOA
18/31
Antennae Cabling
-
8/4/2019 FCOA
19/31
Setting VSWR Standards
-
8/4/2019 FCOA
20/31
Battery Bank Data Entry
-
8/4/2019 FCOA
21/31
Transmission Parameter Setting
-
8/4/2019 FCOA
22/31
E1 Selection
-
8/4/2019 FCOA
23/31
Clock Synchronization
-
8/4/2019 FCOA
24/31
Abis Connection
-
8/4/2019 FCOA
25/31
Abis Allocation
-
8/4/2019 FCOA
26/31
Abis Topology
-
8/4/2019 FCOA
27/31
X Connection
-
8/4/2019 FCOA
28/31
For Remote excess
-
8/4/2019 FCOA
29/31
Downloading of Configuration File
-
8/4/2019 FCOA
30/31
Site Commissioned after Downloading ofconfiguration file
-
8/4/2019 FCOA
31/31
Thanks