case study · 3/22/2017 · case study evotech computer-aided engineering ltd is an engineering...
TRANSCRIPT
www.evotechcae.com | [email protected]
Case Study
Evotech Computer-Aided Engineering Ltd is an Engineering Consultancy based in the UK, specialising in product development through advanced Finite Element Analysis (FEA). With a background predominately in the Aerospace industry, we are expert in multi-scale model development, analysis and structural optimisation, and hold NAFEMS PSE Certification at Advanced level (including Non-Linear Analysis, Composites, Optimisation and FE Model Verification).
Evotech CAE Ltd are highly-experienced in Design Optimisation for product development through Additive Manufacture. This case study highlights the development work with United Launch Alliance to create a structural- and print-optimised design for the boat-tail support brackets, used during ground processing at the base of the Atlas V payload fairing. Much of the work is focussed on the Fossa release of MSC Apex, and its new features.
Project Scope: To develop a structural- and print-optimised internal boat-tail support bracket, manufactured using Fused Deposition Modeling (FDM) with the Stratasys Ultem 9085 Polymer.
Toolsets: MSC Apex Fossa (Direct Modeling Optimisation and Design Verification) & MSC Nastran (Topological Optimisation for Concept Design).
Outcome: Optimised structure, which exhibits 90% mass reduction, a minimum safety factor of 1.01 and a print design requiring no additional support structure.
United Launch Alliance, Atlas V Rocket Hardware
www.evotechcae.com | [email protected]
Sequential Optimisation Strategy;
Topology Optimisation for concept design using minimised compliance solution and a targeted mass fraction of 10%.Design interpretation of initial concept, and subsequent Direct Modeling Optimisation, using the advanced features within MSC
Apex, including ‘Computational Parts’ and version control in a single model environment.Detailed design verification performed for optimised design using stress-converged output.FDM build analysis to demonstrate optimised print performance.
Initial Concept Direct Modeling Analysis Cycles
Detailed Design Verification
•
••
•
3900
4000
4100
4200
4300
4400
4500
4600
4700
4800
4900
0
0.02
0.04
0.06
0.08
0.1
0.12
0.14
0.16
0.18
0.2
Von Mises Stress, Averaged (PSI)
Element Edge Length (Inches)
Design Space
Direct Modeling Optimisation
Final Optimised Design
Topology Optimisation for Concept Design
FDM Build Analysis