build it with project plan magazine rackgo.rockler.com/plans/magazine-rack-project-plan.pdf ·...
TRANSCRIPT
MAGAZINE RACKBUILD IT WITHROCKLER PROJECT PLAN
BUILD QUESTIONS? Go to www.rockler.com
or call 800-279-4441
Standard lumber, 3/4" dowels and Striplox Right-Angle Connectors for attaching the shelves make this an easy DIY project!
Stock # Item55089 Striplox 90D Right-
Angle Connectors (2 sets)
36" x 3/4" dowels (2)20784 Birch20966 Oak
Stock # Item 21097 Cherry21030 Walnut21186 3/4” Forstner bit50179 Titebond® Glue, 8 oz.
All items subject to changes in availability.
MAGAZINE RACK | PAGE 2
1. CUT THESE PIECES 2. DRILL DOWEL SOCKETS
51⁄2"
21⁄2"
x2
x2
3/4" THICK WOOD x2
3/4" WOOD DOWEL x3
9"
60"
105⁄8"
11⁄2" radius
105⁄8"
Use Template A to trace and cut top profile
Use Template B to trace and cut bottom profile
Use a 3/4" Forstner bit to drill 1/2" deep holes. Don’t drill all the way through.
Important: Drill one side as shown and one as a mirror image.
17"
18"
Edge glue narrower boards to reach 9" or desired width
3/4" Forstner bit 21186
41⁄4"
MAGAZINE RACK | PAGE 3
4. INSTALL DOWELS
3. ADD SHELVES
Secure dowels with wood glue
x2
Striplox 90D Right-Angle Connectors, Black55089
Titebond® Original Wood Glue, 8 oz.50179
Use a combination square to mark the desired locations of the shelves. You want the shelves to be parallel to the bottom of the sides.
Use the screws that came with the hardware to attach one Striplox section (“knuckles” facing up) to the side.
Install the mating section on the underside of shelf.
Slide in locking corner plate to secure the connection.
Completed joint. Repeat at remaining shelf corners.
TEMPLATE A – TOP
10"
11⁄2" radius
10°
10°
BO
AR
D O
UTLIN
E
Important: When printing, be sure your print settings specify full size.
1"
TEMPLATE B – BOTTOM
11⁄2" radius
11⁄2" radius
BOARD OUTLINE
10°
Important: When printing, be sure your print settings specify full size.
1"