facebook.com/pages/Born-To-Be-Lash/340886449394734

instagram.com/borntobelash

@borntobelash

youtube.com/user/borntobelash

*Please complete a sensitivity test before application.(This will determine if you are sensitive to the adhesive.)

Thoroughly read instructions before use.

Distribute lash 101C evenly throughout your lash line, reaching the outer corner of your eyes. Use the individual lashes to fill the gaps between all fan lashes. Continue to apply until your eyelashes look full. Choose the amount of lashes you desire. Customize your look! Repeat this step on the other eye.

Lash 101D gives your eyes a featherey look, due to it’s length. Start to apply lash 101D in the middle of your lash line. Space 101D lashes sporadically throughout your lash line, reaching the outer corner. By adding lash 101D to the outer corner of your eyes, it creates the illusion of a “cat eye” and it makes your eyes appear larger. Repeat this step for the other eye. Be sure not to wet your lashes for 24 hours following application. Store the adhesive in a cool area.

For more information visit: www.borntobelash.com.

Born to be Lash is a combination of products and D.I.Y. technique that will enable you to apply a custom set of semi-permanent eyelash extensions. Our products are gentle enough to apply with your eyes open, and you have the ability to apply these lashes in the comfort of your own home. (The best part is it’s affordable and you can maintain them yourself.)

... No more appointments and refills at the lash bar!

Application Manual

Born to be Lash Application Manual - Saleena Fransen.indd 1 15-06-19 11:32 AM

With your eyes open:Place a Fan Lash on the inner corner of your eye, about 4 milimetres away from your tear duct. Place a larger Fan Lash next to the first Fan Lash, leaving a 4 milimetre gap between each lash base. The last strand of each fan lash should touch or overlap. Continue by placing another Fan Lash next to the second Fan Lash, leaving a 4 milimetre gap as well. Apply one more Fan Lash if needed. Depending on the length of your lash line, you could place three or four fan lashes on each eye. Repeat this step on the other eye.

After applying all fan lashes on both eyes, place the individual lashes on top of your natural and fan lashes. The fan lashes act as framework to support the individual lashes. Place about 5 or 6 101A individual lashes directly on top of the first Fan Lash near your tear duct. Apply 101A lashes side by side, try to replicate the natural growth of your lashes! Fill in the gaps between the first two Fan Lashes with 101A lashes. (Remember that your shortest natural lashes are in the inner corner of your eye.) Once you reach the third Fan Lash, begin to alternate between 101C and 101A lashes. Repeat this step on the other eye.

Before you start:• Follow the instructions carefully.• Do a sensitivity test (see below.)• Remove your eye makeup with oil free makeup remover. • Comb your natural lashes out with a lash comb. • Curl your natural lashes (if they are straight and pointy.)• Practice applying a fan lash without the adhesive on your lash line.

(This will give you an understanding on where to position the lash.)

To complete a sensitivity test, dip the tip of an individual lash in the adhesive and place it on the outer corner of your eye. Leave it on for 5 minutes to determine if you are sensitive to the adhesive. Be careful with the adhesive remover when you’re removing your lashes. We recommend working with a partner during the removal process. This manual should be used as basic instruction. Get creative by replacing any of the individual lashes to achieve a unique look. Remember, your natural lashes are supposed to be seen through the fan lashes. The last strands of the fan lashes should touch or overlap. Make sure the lashes are coat-ed with a good amount of adhesive and place them directly on your lash line. When placing the individual lashes, always remember to place them directly on top of the fan and natural lashes.

Dip the fan lash in the adhesive, coating only the tip.

Glide the individual lash through the adhesive, coating only the bottom half. For more information visit: www.borntobelash.com

Born to be Lash Application Manual - Saleena Fransen.indd 2 15-06-19 11:33 AM