wlnn-er-dp551 template

WLNN-ER-DP551Template

Step 1 -

By default the unit is in ethernet role – router with eth dhcp server enabled. This means the device you are plugged into will receive a 192.168.2.XXX address.

Step 2 -

Right click on the device you want to load the template to.

Step 3 -

Verify that your unit applied the template by right clicking on the device choosing template management. You should have an option that allows you to stop using the template.

Step 4 -

Apply the template configuration to the device.

Step 5 -

Close the Airborne Management Center. Be sure to Save your changes!

Step 6 -

When you reopen the Airborne Management Center you should see the device listed with the BridgeTemplateEnterprise with a ETH-IP of 169.254.2.100. The ethernet now adapts a auto ip address of your NIC LAN card.

Step 7 -

You should now be able to access the web interface and see the defaults as listed above. When a factory reset is done it will lead you back to these defaults and not the original ETH role router defaults.