wlnn-er-dp551 template
DESCRIPTION
WLNN-ER-DP551 Template. Step 1-. By default the unit is in ethernet role – router with eth dhcp server enabled. This means the device you are plugged into will receive a 192.168.2.XXX address. Right click on the device you want to load the template to. Step 2 -. - PowerPoint PPT PresentationTRANSCRIPT
WLNN-ER-DP551Template
Step 1 -
By default the unit is in ethernet role – router with eth dhcp server enabled. This means the device you are plugged into will receive a 192.168.2.XXX address.
Step 2 -
Right click on the device you want to load the template to.
Step 3 -
Verify that your unit applied the template by right clicking on the device choosing template management. You should have an option that allows you to stop using the template.
Step 4 -
Apply the template configuration to the device.
Step 5 -
Close the Airborne Management Center. Be sure to Save your changes!
Step 6 -
When you reopen the Airborne Management Center you should see the device listed with the BridgeTemplateEnterprise with a ETH-IP of 169.254.2.100. The ethernet now adapts a auto ip address of your NIC LAN card.
Step 7 -
You should now be able to access the web interface and see the defaults as listed above. When a factory reset is done it will lead you back to these defaults and not the original ETH role router defaults.