wireless setup presentation ppt

Introduction to Wi-Fi Network

It is important to know

1. Nearer access point to you.

2. How to use it efficiently.

3. Firewall disable option.

4. Wireless radio on option.

5. On Demand option .

6. Data backup.

Start Troubleshooting WLAN

Start

> Connect To

> Show all Connections

Disable - Enable - Check

Disable

Local Area Connection

Enable

Wireless Network Connection

Check

WLAN (Radio) LED status on the Front Panel Dashboard.

If LED is not Glowing Check Radio Issues.

Radio Issues

Select 'Wireless Network Connection' Properties (right-click)

Click Configure button to get 'Intel PRO / Wireless LAN ..... adapter' properties

Select Advanced Tab

Remove the Tick mark for 'Wireless Device Off'

Press OK

Check your Front Panel Dashboard WLAN LED status. It should glow for the Laptop to Transmit / Receive data.

Radio Issues (Contd..)

Networking Components Needed for WLAN

● Client for Microsoft Networks

● File and Printer Sharing for Microsoft Networks

● QoS Packet Scheduler

● AEGIS Protocol (IEEE 802.1x) v 2.2.1.0

● WLAN Transport

● Internet Protocol (TCP/IP)

De-select all others

IP Configuration

Don't enter any

IP address

Gateway

DNS address

Select 'automatically' options

Available / Preferred Networks

Select 'Wireless Networks' Tab

Select 'Use Windows to configure my wireless network settings' Check-box

Refresh to see the available networks. Wait for 1-2 minutes & Refresh again

Select 'Advanced' button

Networks to Access

Select 'Access point Infrastructural Networks only' option

Also select 'Automatically connect to non-preferred networks' option

Then close to go back to previous screen

Firewall

Select 'Advanced' Tab

Disable 'Internet Connection Firewall' for the time being.

Go back to 'Wireless Networks' Tab

Refresh again & again till you see a Circle on an available network.

Choose OK to complete the configuration

Wireless Network Connection Status

In case you got this screen, When you select 'Wireless Network Connection' from Task Bar

Select the listed Networks (and click Connect) one-after-the-another, till you get good connection

Select the option 'Allow me ...................even though it is not secure' Option

Troubleshooting with Commands

Start > Run

Type cmd in Run window, to open Command Prompt

c:\> ipconfig /all

Troubleshooting with Commands

If the output shows Gateway as 10.250.0.109, your configuration is correct.

Otherwise, try the following commands:

C:\> ipconfig /release

if wrong/automatic IP address is released, it will display new IP address as 0.0.0.0

Repeat command till you get this new IP address

C:\> ipconfig /renew

It will get new IP address from DHCP server automatically. Check with 'ipconfig /all' command again to verify the gateway.

Output of Fully configured WLAN

Check

DHCP Server: 10.250.0.77

If not, try ipconfig commands....

Ping : Check Connectivity

Finally PING your DHCP Server to get similar output as shown above.

Hope You can configure your Wireless Networks on your Own

For further assistance, contact System Administrators at Server Room