tp series - triple pv · 12 mktg-im-tp34-02-en-1113 installation manual | tp series. 2.9 mount...
Post on 23-May-2020
8 Views
Preview:
TRANSCRIPT
TP Series - Triple PV Top of Pole Solar LED Lighting System
Installation Manual
MKTG-TP34-02-EN-1113
3 MKTG-IM-TP34-02-EN-1113
Installation Manual | TP Series
Important Notes and Warnings
This installation and instruction manual provides installation instructions for the Sol TP Series solar LED lighting systems. The entire contents of this manual should be thoroughly reviewed and understood prior to installing this equipment. Do not discard this manual, as it contains complete installation instructions.
To insure proper operation of this equipment, it is important that the equipment be utilized for its intended use. Any use of this equipment for purposes other than those intended will void all warranties.
Installation and/or troubleshooting should be performed only by qualified personnel. Follow local codes at all times during installation of the Sol TP Series. Consult a contractor for proper installation of poles.
Be very careful when working with batteries.
Do not allow bare ends of the wires to touch each other or grounded metal parts while connected to the controller. This will damage the controller.
This product must be installed in accordance with the applicable installation code by a person familiar with the construction and operation of the product and the hazards involved.
4 MKTG-IM-TP34-02-EN-1113
Installation Manual | TP Series
Batteries (3 or 4)
Battery Enclosure (additonal boxes may be supplied)
Controller
TPM MountFastener Set A (4-8)
Tenon Fastener Set B (3)
Tenon Fastener Set C (3)
Battery Enclosure Channel Fastener Set D (2)
Light Fixture Harness (1 or more)
PV Panel Harness
Battery Harness
Tenon Adaptor
Battery Enclosure Channel Fastener Set E (4)
Battery Enclosure Channel (additional may be sipplied)
Fixture Assembly -Cobrahead or Shoebox
Parts Provided
Battery Cables (1 per battery)
Fastener Set F (2)
Top of Pole Triple/Quad Bracket
Z Rails
Solar Panels - 3 or 4
Ground Wire Fastener Set 1/4”-20 x 3/4”
5 MKTG-IM-TP34-02-EN-1113
Installation Manual | TP Series
1.0 Positioning the Light
2.0 Assembling
2.1 PV Panel Assembly - Triple or Quad Panels. Lay PV panels side by side on cardboard packaging to protect surface.
aTP Mounting Bracket Kit
410016-100
6X
Note: Keep bolts loosely fastened until PV panels are secured.
6 MKTG-IM-TP34-02-EN-1113
Installation Manual | TP Series
Orientation of PV J-boxes should be at top end of panel
16X
b
TP Mounting Bracket Kit410016-100
2.2 Connect PV Harness ( if panels have a panel pan, harness will already be connected).
a
Factory attached harnesss
7 MKTG-IM-TP34-02-EN-1113
Installation Manual | TP Series
b
8 MKTG-IM-TP34-02-EN-1113
Installation Manual | TP Series
2.3 Attach the Tenon Adaptor, Tilted to 30°
45°30°
60°
15°
Tenon Adaptor Kit 320004-005
a
9 MKTG-IM-TP34-02-EN-1113
Installation Manual | TP Series
2.4 Place Solar Panel Assembly on the Pre-Buried Pole - Maximum Pole Height should be 4 feet above ground
PV Modules always face EQUATOR (South in Northern Hemisphere)
a
EQUATOR
2.5 Match Drill Hole in Tenon with Tenon Adaptor and Secure.
a
10 MKTG-IM-TP34-02-EN-1113
Installation Manual | TP Series
2.6 Drill Battery Mounting & Access Holes; Route PV Harness
4.25” below
Access hole for PV Harness. Drill thru one side @ 1.25” Dia.For dual Battery Enclosures drill thru pole.
Battery Enclosure Channel holes:
Drill thru @.87 Dia.28”
6” Min. from top of pole
Note: Battery enclosure may be mounted lower than shown.
a
11 MKTG-IM-TP34-02-EN-1113
Installation Manual | TP Series
2.7 Drill Arm Mounting & Access Holes; Route Fixture Harness
Note: If mounting two arm mounts, connect both using the same bolts. Longer threaded rods will be provided.
Arm Mounting Hole. Drill thru 2x @.75”Dia.
Access hole for Luminaire harness. Drill thru one side @ 1.25” Dia.
a
12 MKTG-IM-TP34-02-EN-1113
Installation Manual | TP Series
2.9 Mount Battery Enclosure
2.8 Secure Battery Enclosure Channel to Pole
Fastener Set D2x 3/4-10 x 12” bolts
Fastener Set E4x 1/4”–20 x 1/2” hex head bolts/washers
PV Harness
Note: Before attaching Battery Enclosure Channel, fish Luminaire Harness down pole through access hole for arm. If mounting two battery enclosures, connect both Channel bars using the provided bolts - longer threaded rods will be provided.
Luminaire Harness
a
a
13 MKTG-IM-TP34-02-EN-1113
Installation Manual | TP Series
2.10 Mount Arm on the Pole
a
2.11 Mount the Light Fixture on the Arm-Cobrahead
Note: Fish Luminaire Harness through arm before attaching.
a
14 MKTG-IM-TP34-02-EN-1113
Installation Manual | TP Series
2.12 Mount the Light Fixture on the Arm-Shoebox
b
Hex key and screws
2.13 Install the Controller
Note: Controller mounting screws are supplied with controller
15 MKTG-IM-TP34-02-EN-1113
Installation Manual | TP Series
2.14 Install the Battery Cables and Battery(s)
a
b
16 MKTG-IM-TP34-02-EN-1113
Installation Manual | TP Series
2.15 Connect the Cables
Batteries (2-4)
Fuse
Wiring Harness
Solar Panels (3-4)
Light Fixture(s) 1-2
EternO 4 Controller
Battery Harness
PV Harness
Fixture LoadHarness
Green Wire (to Ground)secured to upper shelf
17 MKTG-IM-TP34-02-EN-1113
Installation Manual | TP Series
2.16 Test
2.17 Close Battery Enclosure Cover
a
a
18 MKTG-IM-TP34-02-EN-1113
Installation Manual | TP Series
In-Warranty Service Instructions
A Returned Merchandise Authorization (RMA) number must be obtained from Sol Inc. before equipment can be returned for repair or replacement under warranty.
We require the following information before we can issue an RMA number:
• Work Order Number (located inside the battery box) • A description of the problem • The address to which the repaired or replaced product is to be shipped
Equipment being returned must be properly packaged to protect it from damage during shipment. Shipping costs and insurance to Sol Inc. are the responsibility of customer.
Upon verification of failure due to defects in materials or workmanship, we will either repair or replace the product at our discretion. The customer will be responsible for all shipping and handling charges for any equipment that is sent to Sol Inc. in error (no definable problems).
Sol Inc. | 3210 SW 42nd Avenue | Palm City, Florida 34990
www.solarlighting.com
E-mail support: support@solarlighting.com
Phone: +1.772.286.9461 | Toll: 800.959.1329 (USA & Canada)
Fax: +1.772.286.9616
Office Hours: Monday - Friday: 8:30 am to 5:00 pm (EST)
© 2013 Sol Inc. All rights reserved
top related