subli blockmarketing.xpres.co.uk/downloads/instruction-sheets/xp... · 2018. 10. 26. · achieve...

Phone:Web:E-mail:Support:

01332 855 085www.xpres.co.uksales@xpres.co.ukwww.xprestechnical.co.uk

Oakridge Park, Trent LaneCastle Donington, DerbyDE74 2PY

STEP BY STEP

Step 1

Step 2

Step 3

Step 4

Print your design on thesmooth matt side (Do not mirror image) Flock blade required.

Weed away any excess material. If using applicationtape cover with Transfer application tape using a squeegee to remove any air bubbles

Place transfer face up onto the garment (application tape on top) cover with a silicone sheet and press for 20 seconds at 150°C

Remove the silicone sheet cold or peel hot when using application tape

PLEASE NOTE: 500mm x 750mm samples are available free of charge upon request.

Uncoated garments only

Can be ironed inside out

Do not dry clean

Do not tumble dry

Up to 40°C inside out

CARE INFORMATION

TRANSFER SETTINGS

PRESSURE

PEEL

TEMPERATURE

TIME

Medium

Hot or Cold

20 seconds

150°C

Cotton

Polyester

Polyester/Cotton

SUITABLE FOR

PRODUCT INFORMATION

SIZE:

CUTTING FORCE:

APPLICATION TAPE:

50cm & 75cm wide x 20m rolls

FLOCK BLADE

Standard Tack Application tape

Hot or Cold190µ PVC

DURABILITY FINISH PEELMICRONS PU or PVC

®

Subli BlockXP3029 - 50cm wide x 20m roll

XP3035 - 75cm wide x 20m roll

Matt40°C

inside out

PLEASE NOTE: The sellers and manufacturers maximum obligation shall be to replace any product that has been proven to be defective. Neither the seller nor the manufacturer of Subli Block shall be liable for any injury direct or consequential, arising out of the use of, or inability to use this range. Subli Block has been tested using Kustom Kit garments, when applying to other garment brands results may vary, testing prior to purchase is recommended.

ADVISORIES

It is recommended to backweed Subli Block when looking to achieve small detail

Class 2

STORAGE: Store vertically in a dry room between 15-30 °C

Roland: From 65gf / Mimaki: From 55gf

ALL FORCE TESTING HAS BEEN UNDERTAKEN USING A NEW FLOCK BLADE ON A ROLAND SP300I AND A MIMAKI CJV150-75. THE FORCE WILL INCREASE WITH THE AGE OF THE BLADE, THEREFORE ALWAYS TEST PRIOR TO USE.

PRINT SETTINGS

Refer to ‘Textile TransferPrint Settings’ sheet.