phone covers step by step guide

Step-by-Step-by-step guidestep guideTo making your own phone cover luggage tag!

Are you ready? Materials needed: Phone cover! Scissors/Penknife Fine wire/pipe cleaner Ribbon Transparency Super glue or strong glue

Cut out the base of the phone cover with the use of a penknife. Repeated cuts can be made on the edges until the blade cuts through the layer and the sides can be fully removed.

You may use a pair of scissors.

Step One!

Step Two! Cut out 6 thin strips (approximately 2cm shorter

than the length of the phone cover) and 3 thin strips (approximately the width of the phone cover) from the transparency.

Step Three and Four! Paste 3 strips at each length of the phone cover

and 3 strips at the bottom of the cover. Cut out a piece of transparency large enough to

cover the area bounded by the strips and paste it on.

Step Five! Line the sides of the cover with decorative ribbon.

Making the luggage tag Making the luggage tag strap:strap:

Step 1: Choose a piece of ribbon to be used for the strap.

Making the luggage tag Making the luggage tag strap:strap:

Step 2: A metal ring can be made by coiling the wire a few times around a suitably sized pen.

Step 3: Insert the ribbon/fabric through the metal ring as shown below

Making the luggage tag Making the luggage tag strap:strap:

Step 4: Cut out a slip of paper slightly smaller than the size of the transparency and insert it in.

You can then further decorate the luggage tags with various items such as ribbons, buttons and decorative paper or tape on the upper side of the phone cover

VOILA!!!VOILA!!!

Thank Thank You!You!