mpw design introduction course - module 4

1

MPW Design Introduction Course - Module 4

Process Process

DescriptionDescription

Part II

Tyre pressure sensor(SensoNor)

2

Contents Process Description, Part IProcess Description, Part I Cross section overviewCross section overview Key process featuresKey process features MPW process step-by-stepMPW process step-by-step

Process Description, Part II Absolute design limitations Process control monitors Test data

3

Absolute design limitations

To avoid breakage during fabrication

Maximum allowed stress 500 MPa under

the following conditions:

2000 g acceleration

1 bar (0.8 bar) pressure difference

4

Process control monitors Test dies

electrical parameters mechanical dimensions

5

Process control monitors

Product wafers Visual inspection Oxide thickness Diaphragm thickness

Test wafers Sheet resistivity Film thickness

6

Test data Automated test data collection Measurement database Process monitoring / SPC

7

SPC

8

Test certificate

9

Chapter 4:MPW Process Description

End of this chapter Questions or comments?