installation of hyundai dvd gps i30 install buy it now on :

Hyundai i30 Navigation System Installation

Data collected by www.autocardvdgps.com

Dismantle step

1. Original factory stock radio system

2. Use plastic knife to loosen the panel

Powered by www.autocardvdgps.com

3. The panel had been loosen.

4. Loosen two sides of the panel and pay attention to the buckling position

Powered by www.autocardvdgps.com

5. Unplug the harness from the back

6. You can see the CD player after taking out the harness of the frame.

Powered by www.autocardvdgps.com

7. Remove the screws around original radio system

8.Take out the original radio system as follows:

Powered by www.autocardvdgps.com

8. Unplug the harness from the back of the original stock radio system

10. It is done.

Powered by www.autocardvdgps.com

Installation Steps

1. Before installing our head unit

2. Remove the original brackets and install them to our head unit on the two sides The picture shows left bracket

Powered by www.autocardvdgps.com

3. The picture shows right bracket

4. After installing the brackets.

Powered by www.autocardvdgps.com

5. Wire GPS antenna through the dashboard, make sure there is a good signal receipt of the GPS antenna

6. Plug the harness of the speaker

Powered by www.autocardvdgps.com

7. Plug ISO cable

8. All the connectors are ready

Powered by www.autocardvdgps.com

9. All the harness must get through the iron sheet from rear of the car, there is no room to install it .

otherwise ,

10. Here are all the harnesses which get through from the iron sheet of the car

Powered by www.autocardvdgps.com

11. Plug ISO cable connector at the back of this unit

12. Plug the connector of the speaker

Powered by www.autocardvdgps.com

13. Plug the power connector

14. Make sure ISO cable, speaker and power connectors had been plugged properly.

Powered by www.autocardvdgps.com

15. Plug GPS antenna

16. Plug radio antenna

Powered by www.autocardvdgps.com

17. Plug USB connectors

18. All the cables had been connected.

Powered by www.autocardvdgps.com

19. Install our head unit to your car

20. Fasten all the screws

Powered by www.autocardvdgps.com

21. Attach original left & right a/c vent to our frame (provided with head unit)

22. After installing on the frame

Powered by www.autocardvdgps.com

23. Connect air conditioning cables

24. connect the cables as follows:

Powered by www.autocardvdgps.com

25. Make sure air conditioning connectors had been plugged

26. Install the frame

Powered by www.autocardvdgps.com

27. Done! Installation is completed!

For more information, please visit www.autocardvdgps.com

Powered by www.autocardvdgps.com