height adjustable bee bowltraps

Post on 18-Dec-2014

1.402 Views

Category:

Technology

0 Downloads

Preview:

Click to see full reader

DESCRIPTION

An inexpensive system for deploying pan or bowl traps in situations where the height of the vegetation changes the season or prevents bowls from being placed directly on the ground

TRANSCRIPT

By Alex Surcică, Penn State Coop. Ext.

HEIGHT-ADJUSTABLE BEE BOWL TRAPS

The Current Way of Using Bee Bowl Traps

Potential problems with the current way of using bee bowl traps:

Wind and wildlife can easily overturn them and spill the contents;

Bees and researchers may have difficulties locating them in dense vegetation;

There is a high chance that the bowls will be run over by vehicles or stepped on.

Height-Adjustable Bee Bowl Traps

Support Cross with Bowls Attached

This image depicts the wooden cross that has screw-fastened bowls at each end. These bowls will accommodate another set of 4 bowls that will contain the soapy water. This set of bowls should be placed and removed with each bee trapping; this will increase the bowls’ lifespan.

Installing the Height-Adjusting Screw

There should be a hole drilled through the support cross with a diameter that will allow the rebar to pass through. screw should be driven trough the lower part of the cross, aiming for the tip of it to exit in the hole. Once the support cross is positioned on the rebar, by fastening the screw, the height level can be secured.

Installing the Height-Adjusting Screw

Through the support cross should be drilled a hole with a diameter that will accommodate the rebar’s pass through A screw should be driven trough the lower part of the cross, in such a way that its tip will pass through the center of the hole. Once the support cross is positioned on the rebar, by fastening the screw, the height level can be secured.

Installing the Height-Adjusting Screw

Through the support cross should be drilled a hole with a diameter that will accommodate the rebar’s pass through. A screw should be driven trough the lower part of the cross, aiming for the tip of it to exit in the hole. Once the support cross is positioned on the rebar, the height level can be secured by fastening the screw.

Height-Adjustable Bee Bowl Traps

Because it was raining outside, I had to use my Clivia miniata to showcase the system.

Height-Adjustable Bee Bowl Traps

Height-Adjustable Bee Bowl Traps

For questions or suggestions email Alex.Surcica@psu.edu

Height-Adjustable Bee Bowl Traps

top related