global positining system working,errors and correction using dgps department of electronics and...

GLOBAL POSITINING SYSTEM

WORKING,ERRORS AND CORRECTION USING DGPS

Department Of Electronics and Communication Engineering

OBJECTIVE:

To overcome the drawbacks in Global positioning system

by implementing Differential global positioning system .

INTRODUCTION:

The Global Positioning System (GPS) is a satellite-based Navigation system

developed and operated by the US Department of Defense.

GPS Permits land, sea and airborne users to determine their three-dimensional

position and time.

This service is available to military and civilian users around the clock, in all

weather, anywhere in the world.

GPS ELEMENTS:

GPS has 3 parts.

The space segment consists of 24 satellites, each in its own orbit 11,000 nautical

miles above the Earth.

The user segment consists of receivers, which you can hold in your hand or mount

in your car.

The control segment consists of ground stations (five of them, located around the

world) that make sure the satellites are working properly.

Figure representing the elements of GPS

WORKING OF GPS:

The principle behind GPS is the measurement of distance ( "range")

between the receiver and the satellites.

The satellites also tell us exactly where they are in their orbits above the

Earth

Four satellites are required to compute the four dimensions of X, Y, Z

(position) and Time

GPS receivers are used for navigation, positioning, time, and other

research.

A Person using Gps in mountains GPS device which is used for navigation

A Person using Gps to find route in forest A Car consisting Gps to show route maps

SOURCES OF GPS SIGNAL ERRORS:

Factors that can degrade the GPS signal and thus affect accuracy include the

following:

Ionosphere and troposphere delays — the satellite signal slows as it passes through

the atmosphere. The GPS system uses a built-in model that calculates an average

amount of delay to partially correct for this type of error.

Signal multi path — This occurs when the GPS signal is reflected off objects

such as tall buildings or large rock surfaces before it reaches the receiver. This

increases the travel time of the signal, thereby causing errors.

Number of satellites visible — the more satellites a GPS receiver can "see,"

the better the accuracy. Buildings, terrain, electronic interference, or sometimes

even dense fog can block signal reception, causing position errors or possibly no

position reading at all.

Implementing DGPS:

The three main methods currently used for ensuring data accuracy are

real-time differential correction,

reprocessing real-time data,

post processing.

i.Real-Time DGPS Correction

Real-time DGPS occurs when the base station calculates and broadcasts

corrections for each satellite as it receives the data. The correction is received by the

receiver.

ii. Reprocessing Real-Time Data

GPS manufacturers provide software that can correct GPS data that was collected

in real time. If a satellite collecting data can be low on the horizon that it provides

only a weak signal, which causes spikes in the data. Reprocessing real-time data

removes these spikes and allows real-time data that has been used in the field for

navigation

iii. Post processing Correction

Differentially correcting GPS data by post processing uses a base GPS receiver that logs

positions at a known location and a rover GPS receiver that collects positions in the field.

The files from the base and rover are transferred to the office processing software, which

computes corrected positions for the rover's file.

LIMITATIONS OF GPS:

GPS can provide worldwide, three-dimensional positions, 24 hours a day, in

any type of weather. However, the system does have some limitations. There must

be a relatively clear "line of sight" between the GPS antenna and four or more

satellites.

Objects, such as buildings, overpasses, and other obstructions, that shield the

antenna from a satellite can potentially weaken a satellite's signal such that it

becomes too difficult to ensure reliable positioning. These difficulties are

particularly common in urban areas. The GPS signal may bounce off nearby

objects causing another problem called multipath interference.

APPLICATIONS OF GPS:

GPS receivers were used in several aircraft, including F-16 fighters and B-2

bombers

GPS has become important for nearly all military operations and weapons

systems .

GPS is also helping to save lives. Many police, fire, and emergency medical

service units are using GPS receivers to determine the police car, fire truck, or

ambulance nearest to an emergency, enabling the quickest possible response in

life-or-death situations.

Automobile manufacturers are offering moving-map displays guided by

GPS receivers and also demonstrating GPS-equipped vehicles that give

directions to drivers on display screens and through synthesized voice

instructions.

Mapping and surveying companies use GPS extensively.

GPS-equipped balloons are monitoring holes in the ozone layer over the

Polar Regions, and air quality is being monitored using GPS receivers.

CONCLUSION:

GPS a satellite based navigation system, thus can be used to determine the position

of an object on earth. As discussed above, its application field is vast and new

applications will continue to be created as the technology evolves.

REFERENCES: SatelliteCommunication-T.PrattandC.W.Bostain-John

Wiley and Sons.

www.iec.org

www.sss-mag.com

Thank

you