fbthg-70chvl trunk hinge installation instructions
Post on 31-Mar-2015
204 Views
Preview:
TRANSCRIPT
Important Technical Information:
Fesler Billet makes every effort to ensure that you are provided with the most
accurate and up-to-date technical information. However, all technical
information is approximate and may vary upon application. Fesler Billet is not
responsible for any consequences resulting from manufacture’s technical mid-
year changes. Fesler Billet products should only be installed by a qualified,
licensed auto mechanic experienced in the installation of such products.
Important Anodizing Information:
Anodizing does not produce "flawless" color or finish on any Fesler part order
that way. In fact, you should expect to encounter minor variations (or what
some call "blemishes") in the color and finish in individual pieces. Every Fesler
finish is unique in this regard. Remember, these variations are normal, and do
not affect the performance of the part in any way.
Other Important Stuff You Should Probably Read:
Fesler Billet is not responsible for customer applications that are outside the
normal and intended use of our products, including specific model and year
applications.
Fesler Billet designs all parts off original OEM applications. Due to the vast
array of manufacturers for aftermarket parts, it is possible that you may have to
make some minor adjustments to either our part or your sheet metal in order
for the part to fit properly.
QUESTIONS OR COMMENTS?
Call us at 1-866-583-9787
INSTALLATION INSTRUCTIONS
FBTHG-70CHVL HARDTOP
Trunk Hinges
1968 - 1972 Chevrolet Chevelle
INSTALLATION INSTRUCTIONS
1968-1972 Chevrolet Chevelle Trunk Hinges Copyright 2011 © by Fesler Productions, LLC. All rights reserved.
Instructions:
1. Remove four bolts retaining trunk lid and remove trunk lid
2. Remove trunk hinge springs. (Using vise grips or pliers will be helpful)
Each side has hooks on the body that the spring is locked
into.
3. Rotate the spring until the opposite end can be removed from the
hinge.
If you do not care about saving the springs you can cut
them with a die grinder to aid in the removal AFTER
SPRING TENSION IS RELEASED
4. With a die grinder carefully grind the head off the hinge pin
CAREFULLY, ***Be careful not to cut the outer body skin.
An angle die grinder works best. A mirror and light will
also be helpful.
Be sure to protect the carpet and all upholstery
5. After the head of the hinge pin is ground down remove the pin and
hinge.
6. Install new hinges with studs for the struts pointing out towards the
body
7. Line up the bushing with the hinge
pin hole and install the provided
pin. Insert the pin from the center
of the car. >>>>>>>>>>>>>>>>>
8. Install C-clip supplied on the new
hinge pin
a. (Needle nose pliers would work best)
9. Using the lower strut
mount as a template,
hold it against the
trunk hinge support
and push it back
(towards front of car)
and down until there
is no movement. Use
and awl to mark the
three holes.
>>>>>>>>
10. Center punch and drill holes using an angle
drill. >>>>>>>>>>>>>>>>>>>>>>>>>>>>>
11. Install lower strut mount using the three
5/16-18 6H bolts and flat washers. Remove retaining pins from strut
sockets and set aside (you will need to replace them in step 12)
12. Pop struts onto ball studs with the body
attached to the hinge. Replace strut retaining
rings >>>>>>>>>>>>>>>>>>>>>>>>>>>>>>
13. Reinstall trunk lid, attaching hinge to lid with
supplied bolts and washers.
14. Realign lid with car
top related