communication between atlas copco power focus 6000
Post on 02-Oct-2021
3 Views
Preview:
TRANSCRIPT
Communication between Atlas Copco Power Focus 6000 &Mitsubishi Q PLC through NT 50-CC-EN Gateway
1st check the your LAN IP -->
Scan for NT 50 Gateway
Firmware Download in NT 50 Gateway
After Downloading the Firmware the IP Address reset
Again the assign the IP
Insert the GSDML File for PF_6000
Go to Network =>Import Device Description and open the GSDML file
Input/Output Module configuration in NT 50
CC-Link Settings
Profinet IO Settings
Signal Mapping -
Online diagnostics in Sycon-
Data received in diagnostic window – Secondary Transmit
CC –link setting in Mitsubishi PLC
Data mapping in PF 6000 controller –
This Application Note has been provided by Hilscher India
top related