chapter6(interfaces and modem)

5/12/2018 Chapter6(Interfaces and Modem) - slidepdf.com

http://slidepdf.com/reader/full/chapter6interfaces-and-modem 1/5111

Kyung Hee

University

Transmission of Digital DATA :Transmission of Digital DATA :Interfaces and ModemsInterfaces and Modems

Kyung Hee

University

Transmission of Digital Data:Transmission of Digital Data:Interfaces and MODEMsInterfaces and MODEMs

6.1 Digital Data Transmission

6.2 DTE-DCE Interface

6.3 Other Interface Standards

6.4 MODEM

Kyung Hee

University

6.1 Digital Data Transmission6.1 Digital Data Transmission

t Primary concern when considering the transmission of data

from one device to another is the wiring

Kyung Hee

University

Digital Data Transmission(cont’d)Digital Data Transmission(cont’d)

t Parallel Transmission

By grouping, we can send data n bits at a time instead of one

expansive

Kyung Hee

University

tParallel transmission

Kyung Hee

University

tSerial Transmission

one bit follows another

channel,

require interface converter

Kyung Hee

University

t Serial Transmission

Kyung Hee

University

tAsynchronous Transmission

send one start bit(0) at the beginning and one or more stop

bits(1) at the end of each byteeg) the connection of a terminal to a computer

cheap and effective

Kyung Hee

University

Asynchronous here means “asynchronous at the byte level,”

but the bits are still synchronized;

their durations are the same.

Kyung Hee

University

Digital Data TransmissionDigital Data Transmission

t synchronous transmission

Sending bits one after another without start/stop bits or gaps. Itis the responsibility of the receiver to group the bits

The receiver counts the bits as they arrive and groups them in

eight-bit units

t 장점 : 속도 (speed)

Kyung Hee

University

6.2 DTE-DCE Interface6.2 DTE-DCE Interface

tDTE(Data Terminal equipment)

tDCE(Data Circuit-terminating Equipment)

Kyung Hee

University

DTE-DCE Interface(cont’d)DTE-DCE Interface(cont’d)

tDTE(Data Terminal Equipment)

~ is any device that is a source of destination for binary digital

terminal

microcomputer

computer

printer

fax machine and so on

Kyung Hee

University

tDCE (Data Circuit-Terminating Equipment)

~ is any device (functional unit) that transmits or

receives data in the form of an analog or digital

signal through a network

q Modulator/demodulator

Kyung Hee

University

t Standards

defining the connection between a DTE and DCE

Kyung Hee

University

tStandards

EIA (Electronic Industries Association)q EIA-232

q EIA-442

q EIA-449

ITU-T (International Telecommunication Union-Telecommunication Sector)

q V series

q X series

Kyung Hee

University

t EIA-232(RS-232)

defining the mechanical, electrical and functionalcharacteristics

tmechanical

defining the interface as a 25-wire cable with a male (plug) and

a female (receptacle) DB-25 pin connector length may not exceed 15m(50 feet)

t electrical specification

define voltage levels and the type of signal(NRZ-L)

Kyung Hee

University

t sending the data

To be recognized as data, the amplitude of a signal must fallbetween 3 and 15 volts or between –3 and –15 volts

Kyung Hee

University

t control and timing

Only 4 wires out of 25 available in an EIA-232 interface are usedfor data functions

Signals must be sent using OFF less than –3 volts and ON

greater than +3 volts

Kyung Hee

University

tFunctional Specification

Kyung Hee

University

t synchronous full-duplex transmission

Kyung Hee

University

Kyung Hee

University

t Null Modem

not needed to connect two compatible digital devices directly

t Using regular data pin connections with and without DCEs

Kyung Hee

University

t Crossing Connections

tNull modem pin connection

6 3 O h I f S d d

Kyung Hee

University

6.3 Other Interface Standards6.3 Other Interface Standards

tneeds more speed and/or distance

EIA-449

EIA-530

O h I f S d d ( ’d)Oth I t f St d d ( t’d)

Kyung Hee

University

Other Interface Standards(cont’d)Other Interface Standards(cont’d)

t EIA-449

DB-37 pin

DB-9 pin

t DB-37 and DB-9 connections

Oth I t f St d d ( t’d)Oth I t f St d d ( t’d)

Kyung Hee

University

tPin Functions

category I pins

~ are compatible with those of EIA-232

category II pins

~ have no equivalent in EIA-232

Oth I t f St d d ( t’d)Oth I t f St d d ( t’d)

Kyung Hee

University

t DB-37 pins

Pin Functions Category Pin Functions Category1234567

8910111213141516171819

ShieldSignal rate indicator UnassignedSend dataSend timingReceive dataRequest to send

Receive timingClear to sendLocal loopback Data modeTerminal readyReceive readyRemote loopback Incoming callSelect frequency

Terminal timingTest modeSignal ground

20212223242526

2728293031323334353637

Receive CommonUnassignedSend dataSend timingReceive dataRequest to sendReceive timing

Clear to sendTerminal in serviceData modeTerminal readyReceive readySelect readySignal quality New signalTerminal timing

Standby indicator Send common

Oth I t f St d d ( t’d)Other Interface Standards(cont’d)

Kyung Hee

University

t DB-9 pins

Pin Function EIA-232 Equivalent

Shield

Secondary receive ready

Secondary send data

Secondary receive data

Signal ground

Receive common

Secondary request to send

Secondary clear to sendSend common

Kyung Hee

University

tElectrical specification : RS-423 and RS-422

EIA-449 uses two other standards to define its electricalspecification

RS-423 (unbalanced circuits)

RS-422 (balanced circuits)

Kyung Hee

University

Other Interface Standards(cont’d)Other Interface Standards(cont d)

t RS-423 : Unbalanced Mode

Kyung Hee

University

Other Interface Standards(cont d)Other Interface Standards(cont d)

t RS-422 : Balanced Mode

Kyung Hee

University

tCanceling of noise using balanced mode

Kyung Hee

University

tEIA-530

is a new version of EIA-449 that uses DB-25 pins

Kyung Hee

University

~ is an interface designed by the ITU-T to address many of the problemsexisting in the EIA

eliminating most of the control circuits of the EIA standards

DB-15 connector

Byte timing (pins 7 and 14) : byte synchronization

Control and indication

– Pin 3 : equivalent of request to send

– Pin 5 : equivalent of clear to send

Other Interface StandardsOther Interface Standards

Kyung Hee

University

Other Interface StandardsOther Interface Standards

t DB-15 pins

Pin Function

Function

Shield

Transmit data or control

Control

Receive data or control

Indication

Signal element timing

Bye timing

Signal ground

Transmit data or control

Control

Receive data or control

Indication

Signal element timing

Byte timing

Reserved

6 4 MODEMs6.4 MODEMs

Kyung Hee

University

6.4 MODEMs6.4 MODEMs

t the most familiar type of DCE

MODEMs(cont’d)MODEMs(cont’d)

Kyung Hee

University

MODEMs(cont d)MODEMs(cont d)

tMODEM

stands for modulator/demodulator

Modulator : converts a digital signal to an analog signal

q using the digital-to-analog mechanism of ASK, FSK,

PSK, and QAM

Demodulator : converts an analog signal to a digital

signal

Kyung Hee

University

MODEMs(cont d)MODEMs(cont d)

tTransmission Rate

Bandwidthq Each line has an upper limit and a lower limit on the

frequencies of the signals it can carry. This limited range is

called the bandwidth

Kyung Hee

University

MODEMs(cont d)( )

t Telephone line bandwidth

A telephone line has bandwidth of almost 3000 Hz

Used for dataUsed for voice

Kyung Hee

University

( )( )

t Modem speed

The bandwidth required for ASK transmission is equal to baud rate of

signal

in half-duplex ASK, because the effective bandwidth of a telephone

line is 2400Hz, the maximum bit rate is also 2400.

Kyung Hee

University

( )( )

t Baud rate in full-duplex ASK

Although ASK has a good bit rate, it is not used today because of noise

Kyung Hee

University

( )( )

t FSK(Frequency Shift Keying)

Baud rate in half-duplex FSK

Baud rate in full-duplex FSK

Kyung Hee

University

t PSK and QAM

Encoding Half-Duplex Full-Duplex

ASK, FSK, 2-PSK

4-PSK, 4-QAM

8-PSK, 8-QAM16-QAM

32-QAM

64-QAM

128-QAM

256-QAM

72009600

12,000

14,400

16,800

36004800

19,200 9600

Theoretical bit rates for modemsTheoretical bit rates for modems

Kyung Hee

University

tModem Standards

Bell modem

q The first commercial modems in the early 1970s

ITU-T modem

Kyung Hee

University

t Bell Modems(cont’d)

For flow control or error control

Kyung Hee

University

t Bell Modems

212 --> 201 : Same technology, data rate double

Kyung Hee

University

t ITU-T Modem Standards(cont’d)

Kyung Hee

University

t ITU-T Modem Standards

Kyung Hee

University

t ITU-T/Bell Compatibility

ITU-T Bell Baud Rate Bit Rate Modulation

V.23V.26

202201

12001200

12002400

FSK 4-PSK

16-QAM

Kyung Hee

University

t Intelligent Modems

~ contain software to support a number of additional function,such as automatic answering and dialing

AT Command[parameter] command[parameter]…

Ex) ATDT4088648902

Kyung Hee

University

t AT commands

Command Meaning Parameters

Put modem in answer mode

Use V.22bis at 1200 bps

Dial the number

Enable/disable echo printing

Put modem on/off hook

Adjust speaker volume

Use pulse dialing

Use tone dialing

The number to dial

0 or 10 or 1

chapter6(interfaces and modem)

Documents

chapter6 pages

baron chapter6

chapter6...

equity chapter6

al2ed chapter6

savi chapter6

chapter6 permeability

final chapter6

exercise chapter6

docsis 3.1 modem / voice equipment · docsis 3.1 modem /...

chapter6 t

chapter6 mchaney

acct2121 chapter6

chapter6 mba

docsis 3.1 modem / voice equipment...docsis 3.1 modem /...

csajsp chapter6

bis chapter6

quantitative chapter6

econ chapter6

es chapter6