accessibility details for doors, maneuvering spaces & routes

7
FIGURE 11 B-304.3.2 T-SHAPEQ TURNING SPACE dimension showing English units (in inches unless otherwise specified) above the line and SI units (in millimeters unless otherwise specified) below the line dimension for small measurements dimension showing a range with minimum - maximum minimum maximum greater than greater than or equal to less than less than or equal to boundary of c lear floor space or maneuvering clearance centerline a permitted element or its extension direction of travel or approach a wall floor, ceiling or other element cut in section or plan a highlighted element in elevation or plan location zone of element, control or feature Description Convention forward parallel 36 914 6 152 33-36 838-914 min max > > < <                                                INFORMATION BULLETIN / PUBLIC - BUILDING CODE REFERENCE NO.: LABC Sec. 11B-304,305,404 Effective: 01/01/2020 DOCUMENT NO.: P/BC 2020-086 Revised: Previously Issued As: P/BC 2017-086 ACCESSIBILITY DETAILS FOR DOORS, MANEUVERING SPACES & ROUTES 30" MIN UNLESS SPECIFICALLY STATED OTHERWISE, FIGURES ARE PROVIDED FOR INFORMATIONAL PURPOSES ONLY. (11B-104.3 FIGURES) (b) T-SHAPED SPACE FOR 180 O TURNS (a) 60 INCHES DIAMETER SPACE WHEELCHAIR TURNING SPACE FIGURE 11B-104 GRAPHIC CONVENTION FOR FIGURES 48" MIN FIGURE 11B-305.3 CLEAR FLOOR OR GROUND SPACE FIGURE 11B-305.5 POSITION OF CLEAR FLOOR OR GROUND SPACE As a covered entity under Title II of the Americans with Disabilities Act, the City of Los Angeles does not discriminate on the basis of disability and, upon request, will provide reasonable accommodation to ensure equal access to its programs, services and activities. Page 1 of 7

Upload: others

Post on 26-Nov-2021

3 views

Category:

Documents


0 download

TRANSCRIPT

FIGURE 11 B-304.3.2 T-SHAPEQ TURNING SPACE

dimension showing English units (ininches unless otherwise specified)above the line and SI units (inmillimeters unless otherwise specified)below the linedimension for small measurements

dimension showing a range withminimum - maximumminimummaximumgreater thangreater than or equal toless thanless than or equal toboundary of c lear floor space ormaneuvering clearancecenterlinea permitted element or its extension

direction of travel or approach

a wall floor, ceiling or other elementcut in section or plan

a highlighted element inelevation or plan

location zone of element, control orfeature

DescriptionConvention

forward parallel

36914

6 152

33-36838-914

minmax

>>

<<

 

 

 

 

 

               

  

    

       

  

 

         

 

    

INFORMATION BULLETIN / PUBLIC - BUILDING CODE REFERENCE NO.: LABC Sec. 11B-304,305,404 Effective: 01/01/2020

DOCUMENT NO.: P/BC 2020-086 Revised: Previously Issued As: P/BC 2017-086

ACCESSIBILITY DETAILS FOR DOORS, MANEUVERING SPACES & ROUTES

30" MIN

UNLESS SPECIFICALLY STATED OTHERWISE, FIGURES ARE PROVIDED FOR INFORMATIONAL PURPOSES ONLY. (11B-104.3 FIGURES)

(b) T-SHAPED SPACE FOR 180O TURNS

(a) 60 INCHES DIAMETER SPACE

WHEELCHAIR TURNING SPACE

FIGURE 11B-104 GRAPHIC CONVENTION

FOR FIGURES

48" MIN

FIGURE 11B-305.3 CLEAR FLOOR OR GROUND SPACE

FIGURE 11B-305.5 POSITION OF CLEAR FLOOR OR GROUND

SPACE

As a covered entity under Title II of the Americans with Disabilities Act, the City of Los Angeles does not discriminate on the basis of disability and, upon request, will provide reasonable accommodation to ensure equal access to its programs, services and activities.

Page 1 of 7

RUBBER BUMPER ON CHAIR

 

 

     

  

 

 

 

  

 

    

   

 

 

   

              

          

 

   

   

P/BC 2020-086

THESE DIAGRAMS ILLUSTRATE THE SPECIFIC REQUIREMENTS OF THESE REGULATIONS AND ARE INTENDED ONLY AS AN AID FOR BUILDING DESIGN AND CONSTRUCTION.

DOORS & MANEUVERING SPACE 60" MIN

48" MIN

PULL SIDE

24" MIN

18" MIN

CLEAR AT EXTERIOR DOORS

CLEAR AT INTERIOR DOORS

PROVIDE THIS ADDITIONAL SPACE IF DOOR IS EQUIPPED WITH BOTH A LATCH AND A CLOSER

PUSH SIDE

12" MIN

FRONT APPROACH

10" MIN. BOTTOM RAIL

DOOR CONSTRUCTION

60" MIN

44" MIN

48" MIN

22" MIN 22" MIN36" MIN

HINGE APPROACH, PULL SIDE HINGE APPROACH, PUSH SIDE HINGE APPROACH, PUSH SIDE, DOOR

PROVIDED WITH BOTH CLOSER AND LATCH

FIGURE 11B-404.2.4.1 MANEUVERING CLEARANCES AT MANUAL SWINGING DOORS AND GATES

As a covered entity under Title II of the Americans with Disabilities Act, the City of Los Angeles does not discriminate on the basis of disability and, upon request, will provide reasonable accommodation to ensure equal access to its programs, services and activities.

Page 2 of 7

latch approach, push sidelatch approach, push side, door provided with closer

(C) folding door

(b) sliding door

(a) hinged door

FIGURE 11B-404.2.4.1—continued MANEUVERING CLEARANCES AT MANUAL SWINGING DOORS AND GATES

  

 

 

  

 

 

 

 

 

 

P/BC 2020-086 THESE DIAGRAMS ILLUSTRATE THE SPECIFIC REQUIREMENTS OF THESE REGULATIONS AND ARE INTENDED ONLY AS AN AID FOR BUILDING DESIGN AND CONSTRUCTION.

DOORS & MANEUVERING SPACE

FIGURE 11B-404.2.3CLEAR WIDTH OF DOORWAYS

TABLE 11B-404.2.3MANEUVERING CLEARANCES AT MANUAL SWINGING DOORS AND GATES

TYPE OF USE MINIMUM MANEUVERING CLEARANCE

APPROACH DIRECTION DOOR or GATE SIDE PERPENDICULAR TO

DOORWAY PARALLEL TO DOORWAY

(beyond latch side unless noted)

From front Pull 60 inches 18 inches

From front Push 48 inches 0 inches

From hinge side Pull 60 inches 36 inches

From hinge side Push 44 inches 22 inches

From latch side Pull 60 inches 24 inches

From latch side Push 44 inches 24 inches

1. ADD 12 INCHES IF CLOSER AND LATCH ARE PROVIDED. 2. ADD 4 INCHES IF CLOSER AND LATCH ARE PROVIDED. 3. BEYOND HINGE SIDE. 4. ADD 4 INCHES IF CLOSER IS PROVIDED. 5. ADD 6 INCHES AT EXTERIOR SIDE OF EXTERIOR DOORS.

As a covered entity under Title II of the Americans with Disabilities Act, the City of Los Angeles does not discriminate on the basis of disability and, upon request, will provide reasonable accommodation to ensure equal access to its programs, services and activities.

Page 3 of 7

(b) side approach

(a) front approach

(C) pocket or hinge approach

(d) stop or latch approach

 

 

   

 

 

   

 

   

 

   

P/BC 2020-086 THESE DIAGRAMS ILLUSTRATE THE SPECIFIC REQUIREMENTS OF THESE REGULATIONS AND ARE INTENDED ONLY AS AN AID FOR BUILDING DESIGN AND CONSTRUCTION.

DOORS & MANEUVERING SPACE

FIGURE 11B-404.2.4.2MANEUVERING CLEARANCES AT DOORWAYS WITHOUT DOORS, SLIDING DOORS,

GATES, AND FOLDING DOORS

TABLE 11B-404.2.4.2MANEUVERING CLEARANCES AT DOORWAYS WITHOUT DOORS OR GATES

MANUAL SLIDING DOORS AND MANUAL FOLDING DOORS

MINIMUM MANEUVERING CLEARANCE

Approach direction Perpendicular to doorway Parallel to doorway (beyond stop/latch side unless noted)

From Front 48 inches 0 inches

From Side1 42 inches 0 inches

From pocket/hinge side 42 inches 22 inches

From stop/latch side 42 inches 24 inches

1. Doorway with no door only. 2. Beyond pocket/hinge side

As a covered entity under Title II of the Americans with Disabilities Act, the City of Los Angeles does not discriminate on the basis of disability and, upon request, will provide reasonable accommodation to ensure equal access to its programs, services and activities.

Page 4 of 7

(C) push side, door provided with

both closer and latch

(b) push side

(a) pull side

 

 

 

 

 

 

               

      

     

     

 

 

   

    

P/BC 2020-086 THESE DIAGRAMS ILLUSTRATE THE SPECIFIC REQUIREMENTS OF THESE REGULATIONS AND ARE INTENDED ONLY AS AN AID FOR BUILDING DESIGN AND CONSTRUCTION.

DOORS & MANEUVERING SPACE

48" MIN 48" MIN

(a) (b)

48" MIN

(c)

FIGURE 11B-404.2.6DOORS IN SERIES AND GATES IN SERIES

As a covered entity under Title II of the Americans with Disabilities Act, the City of Los Angeles does not discriminate on the basis of disability and, upon request, will provide reasonable accommodation to ensure equal access to its programs, services and activities.

Page 5 of 7

(a ) SINGLE DOOR

(b) DOUBLE DOOR

(C)PASSAdominant direction of travel

AN ADULT SIZE WHEELCHAIR AVERAGES 27 INCHES IN WIDTH. THE REQUIRED 32 INCH CLEAR OPENING ALLOWS 2-1/2 INCHES ON EACH SIDE FOR HANDS.

long dimension perpendicular to dominant direction of travel

FIGURE 11B-302.2 CARPET PILE HEIGHT

FIGURE11B-303.2 VERTICAL CHANGE IN LEVEL

FIGURE 11B-303.3 BEVELED CHANGE IN LEVEL

FIGURE 11B-302.3 ELONGATED OPENINGS IN FLOOR OR GROUND SURFACES

 

 

11B-404.2.3

             * NOTE: SEE FIGURE 11B-404.2.3

 

   

 

  

     

 

P/BC 2020-086 THESE DIAGRAMS ILLUSTRATE THE SPECIFIC REQUIREMENTS OF THESE REGULATIONS AND ARE INTENDED ONLY AS AN AID FOR BUILDING DESIGN AND CONSTRUCTION.

ACCESSIBLE ROUTES

11B-404.2.3

Door openings shall provide a clear width of 32 inches minimum. Clear openings of doorways with swinging doors shall be measured between the face of the door and the stop, with the door open 90 degrees. Openings more than 24 inches deep shall provide a clear opening of 36 inches minimum. There shall be no projections into the required clear opening width lower than 34 inches above the finish floor or ground. Projections into the clear opening width between 34 inches and 80 inches above the finish floor or ground shall not exceed 4 inches.

11B-404.2.5 THRESHOLDS, IF PROVIDED AT DOORWAYS, SHALL BE 1/2 INCH HIGH MAXIMUM. RAISED THRESHOLDS AND CHANGES IN LEVEL AT DOORWAYS SHALL COMPLY WITH SECTIONS 11B-302 AND 11B-303.

As a covered entity under Title II of the Americans with Disabilities Act, the City of Los Angeles does not discriminate on the basis of disability and, upon request, will provide reasonable accommodation to ensure equal access to its programs, services and activities.

Page 6 of 7

(a) 180 degree turn

(b) 180 degree turn

(Exception)

(a) single space

(b) two spaces

(b) side entry

(a) front or rear

entry

FIGURE 11B-802.1.2 WIDTH OF WHEELCHAIR SPACES

FIGURE 11B-802.1.3 DEPTH OF WHEELCHAIR SPACES

FIGURE 11B-403.5.1 CLEAR WIDTH OF AN ACCESSIBLE ROUTE

FIGURE 11B-403.5.2 CLEAR WIDTH AT TURN

 

 

 

 

               

 

 

 

      

P/BC 2020-086 THESE DIAGRAMS ILLUSTRATE THE SPECIFIC REQUIREMENTS OF THESE REGULATIONS AND ARE INTENDED ONLY AS AN AID FOR BUILDING DESIGN AND CONSTRUCTION.

ACCESSIBLE ROUTES

ACCESSIBLE ROUTE OF TRAVEL

11B-403.5.1SEE CLEAR WIDTH AND EXCEPTIONS

REQUIREMENTS

As a covered entity under Title II of the Americans with Disabilities Act, the City of Los Angeles does not discriminate on the basis of disability and, upon request, will provide reasonable accommodation to ensure equal access to its programs, services and activities.

Page 7 of 7