2_ safety

MINI-LINK TN R4

SAFETY

Top right corner for field-mark, customer or partner logotypes. See Best practice for example.

Slide title 40 pt

Slide subtitle 24 pt

Text 24 pt

Bullets level 2-520 pt

© Ericsson AB 2007 LZU 108 6895 R1A Figure 1- MINI-LINK TN System Description2

Microwave Radiation considerations:• The maximum RF exposure levels around and in front of the antennas do not exceed the limits for occupational exposure.• The maximum RF exposure levels do not exceed the general public limits outside the compliance boundary (as shown to the left)

• Do not work directly in front of the antenna, since this will disturb or interrupt the signal.• The transmitter should be switched off before dismounting the equipment.5m (16ft 5")


Slide title 40 pt


Text 24 pt



HazardsWorking on Heights

• Personnel working at heights must have the

appropriate training and medical certificate.

• Full body safety harness and safety helmet must be used.

• Adequate protective clothing is essential in cold weather.

• No one is allowed to be located below the area where the work is performed.

• Never work alone in the mast.


Slide title 40 pt


Text 24 pt



• Use tested and approved hoisting devices only. Trained personnel must operate the hoisting device.• Always check that all parts of the hoisting device are intact.• Make sure that all hoisting devices are properly stabilized and attached to fixed objects, such as walls or buildings, before hoisting.• Always hoist the equipment in the specified hoisting points.• Never walk under hoisted loads.• Follow local regulations for safety clothing and safety equipment for hoisting or moving goods.

When hoisting materials think of the following points:


Slide title 40 pt


Text 24 pt



2_ safety

Documents