1 introduction to organic electronics mohammad agahian panahi university of tehran, ece faculty vlsi...
TRANSCRIPT
11
Introduction to Organic Introduction to Organic ElectronicsElectronics
Mohammad Agahian PanahiUniversity of Tehran, ECE faculty
VLSI Course PresentationInstructor: Dr. S. M. Fakhraie
Main References:
• J. M. Shaw, P. F. Sieldler “Organic electronics: Introduction” J. M. Shaw, P. F. Sieldler “Organic electronics: Introduction” IBM J. Res. & Dev. Vol. 45 No. 1 January 2001IBM J. Res. & Dev. Vol. 45 No. 1 January 2001• W. E. Howard, O. F. Prache “Microdisplays based upon W. E. Howard, O. F. Prache “Microdisplays based upon organic light emitting diodes” IBM J. Res. & Dev. Vol. 45 No. organic light emitting diodes” IBM J. Res. & Dev. Vol. 45 No. 1 January 20011 January 2001
22
OutlineOutline
Organic vs. Inorganic TransistorsOrganic vs. Inorganic TransistorsOrganic LEDs (OLED)Organic LEDs (OLED)OLED ApplicationsOLED Applications
33
Organic vs. InorganicOrganic vs. Inorganic Inorganic Transistors: silicon and gallium
arsenide semiconductors, metals such as aluminum and copper
Organic Transistors: Organic transistors are transistors that use organic molecules rather than silicon for their active material. This active material can be composed of a wide variety of molecules. Organic molecules are Polymers, Oligomers, etc.
Improvement in semiconducting, conducting, light emitting and physical properties (to be discussed)
44
Polymers and Wiring ImprovementsPolymers and Wiring Improvements
Negative effect of interconnect of 7 layers of metal because of Resistance and Capacitance: propagation delay and cross talk.
R reduction: Copper instead of AluminumC reduction: Polymeric material SiLK
instead of oxide insulators.
Result: 37% improvement in wiring performance, so on-chip wiring is not a performance limiter for next decade.
55
Charge (hole & electron) TransportCharge (hole & electron) Transport
Schematic of organic semiconducting p-type transistor with top contacts [1]
• Usually comprised of many individual molecules Usually comprised of many individual molecules held together by Van der Waals forces held together by Van der Waals forces
66
Huge variety of choices for organic molecules for use in semiconductors
The ability of these materials to transport charge due to P-orbital overlap of neighbouring molecules provides semiconducting and conducting properties
Charge transport significantly different material to material
The major factor limiting mobility, takes place from molecule to molecule
P-orbital overlap is key to improvments in mobility of carriers
Charge (hole & electron) TransportCharge (hole & electron) Transport
77
Classes of organic molecules for use in semiconductors and
their mobility [1]
• Lower mobility than silicon crystal, because they are polycrystalline • These carrier mobilities are useful for application that do not require high switching speeds
• Pentacene polymer has achieved mobilities comparable to that of the amorphous silicon used to fabricate the thin film transistors (TFTs) which drive the liquid crystal pixels in LCD flat panel displays
88
Development of MobilityDevelopment of Mobility
Performance of organic and hybrid semiconductors [1]
• Mobilities of organic semiconductors have improved by five orders of magnitude over the past 15 years.
99
AdvantagesAdvantages
Manufactured in low temperaturesManufactured in low temperatures Low cost & great flexibility in their synthesisLow cost & great flexibility in their synthesis
Inkjet printingInkjet printing Vacuum evaporationVacuum evaporation Solution castingSolution casting ……
Good mechanical propertiesGood mechanical properties FlexibilityFlexibility ToughnessToughness
[2]
1010
DisadvantageDisadvantage
lower mobility and switching speeds lower mobility and switching speeds compared to silicon waferscompared to silicon wafers
1111
What is OLED ?What is OLED ?OLED stands for Organic Light Emitting DiodeOLED stands for Organic Light Emitting Diode
•Alq3 as electron and NPB as hole transport layer•Electrons injected from the cathode (Ca, Al, Ba, etc.)•Holes injected from anode (Indium thin oxide, PEDOT)•Transport and radiative recombination of electron & hole at emissive layer
Schematic of typical OLED [1]
1212
PropertiesProperties
•These devices promise to be much less costly to fabricate than traditional LEDs.
•OLEDs are available as distributed sources while the inorganic LEDs are point sources of light.
•One of the great benefits of an OLED display over the traditional LCD displays is that OLEDs do not require a backlight to function. This means that they draw far less power
]2[
1313
Potentials of OLEDsPotentials of OLEDs
Suitable for thin, lightweight, printable Suitable for thin, lightweight, printable displaysdisplays
Good contrastGood contrastHigh resolution (< 5 micron pixel size)High resolution (< 5 micron pixel size)Fast switching (1-10 micro seconds)Fast switching (1-10 micro seconds)Wide viewing angleWide viewing angleLow cost of materials and fabricationLow cost of materials and fabrication
1414
OLED TypesOLED Types Small-molecule OLEDSmall-molecule OLED
Developed by Eastman-KodakDeveloped by Eastman-Kodak Made by vacuum evaporating small molecules to Made by vacuum evaporating small molecules to
substrate similar to that used in semiconductor substrate similar to that used in semiconductor manufacturingmanufacturing
Expensive processExpensive process
Polymer OLEDPolymer OLED Developed by Cambridge Display TechnologyDeveloped by Cambridge Display Technology Know as PLED (Polymer LED)Know as PLED (Polymer LED) Cheap & Easier production technique: Made by Cheap & Easier production technique: Made by
depositing the polymer on substrate through an inkjet depositing the polymer on substrate through an inkjet printing process printing process
Fabrication of large screen sizesFabrication of large screen sizes
1515
Inkjet printingInkjet printing
Advantage: high resolution, material saving, low cost
[3]
1616
AdvantagesAdvantages Lower cost than LCDs and Plasma displays, can be printed onto a substrate Lower cost than LCDs and Plasma displays, can be printed onto a substrate
using traditional inkjet technologyusing traditional inkjet technology
more scalable manufacturing process enables the possibility of much larger more scalable manufacturing process enables the possibility of much larger displays and highr resolutiondisplays and highr resolution
Unlike LCDs which employ a back-light and are incapable of showing true Unlike LCDs which employ a back-light and are incapable of showing true black, an off OLED element produces no light allowing for infinite contrast black, an off OLED element produces no light allowing for infinite contrast ratios.ratios.
The range of colors, brightness, and viewing angle possible with OLEDs are The range of colors, brightness, and viewing angle possible with OLEDs are greater than that of LCDs or plasma displays.greater than that of LCDs or plasma displays.
Without the need of a backlight, OLEDs use less than half the power of LCD Without the need of a backlight, OLEDs use less than half the power of LCD displays and are well-suited to mobile applications such as cell phones and displays and are well-suited to mobile applications such as cell phones and digital cameras.digital cameras.
OLEDs can be printed onto flexible substratesOLEDs can be printed onto flexible substrates
1717
DisadvantageDisadvantage
Relationshio between brightness and lifetime is Relationshio between brightness and lifetime is linear, high brightness level require the display linear, high brightness level require the display driving voltage levels to be increased which driving voltage levels to be increased which trades off expected life timetrades off expected life time
intrusion of moisture into displays damages and intrusion of moisture into displays damages and destroys the organics materialsdestroys the organics materials• improved sealing processes are important for
practical manufacturing
1818
OLED ApplicationsOLED Applications
Current ApplicationsCurrent ApplicationsDigital camera (Kodak)Digital camera (Kodak)Mobile phone screen (Motorola, NEC, Mobile phone screen (Motorola, NEC,
Samsung)Samsung)Car stereo (Pioneer, Kenwood)Car stereo (Pioneer, Kenwood)40 inch OLED display (Samsung) [3]40 inch OLED display (Samsung) [3]
Future ApplicationsFuture ApplicationsFlexible displaysFlexible displaysMicrodisplaysMicrodisplays
1919
Flexible DisplaysFlexible Displays
Flexible substrate requirementsFlexible substrate requirements TransparencyTransparency RobustnessRobustness Low costLow cost StabilityStability
Low coefficient of thermal deformationLow coefficient of thermal deformation Low moisture absorptionLow moisture absorption Resistant to chemical and solventsResistant to chemical and solvents
Processing temperature limited by:Processing temperature limited by: Deformation temperature of substrateDeformation temperature of substrate
2020
Flexible DisplayFlexible Display
Monochrome (green) flexible OLED display [2](click to play)
2121
MicrodisplaysMicrodisplays
High resolution at small areaHigh resolution at small area
Headsets for viewing movies and Headsets for viewing movies and cell phones with cell phones with full screenfull screen internet accessinternet access
Wearable headset monitors [4]Schematic view of the optics of a microdisplay
2222
Packaged OLED-on-silicon chipOLED-on-silicon SXGA microdisplay specification
Cross section of the OLED-on-silicon SXGA microdisplay [4]
2323
ReferencesReferences 1. J. M. Shaw, P. F. Sieldler “Organic electronics: 1. J. M. Shaw, P. F. Sieldler “Organic electronics:
Introduction” IBM J. Res. & Dev. Vol. 45 No. 1 January Introduction” IBM J. Res. & Dev. Vol. 45 No. 1 January 20012001
2. web resource: 2. web resource: www.oled-display.net
3. Clarck W. Crawford, “Organic Light Emitting Diodes 3. Clarck W. Crawford, “Organic Light Emitting Diodes Have Bright Future in Flat Panel Displays”, Technology Have Bright Future in Flat Panel Displays”, Technology commercialization Alliance, 2003commercialization Alliance, 2003
4. W. E. Howard, O. F. Prache “Microdisplays based 4. W. E. Howard, O. F. Prache “Microdisplays based upon organic light emitting diodes” IBM J. Res. & Dev. upon organic light emitting diodes” IBM J. Res. & Dev. Vol. 45 No. 1 January 2001Vol. 45 No. 1 January 2001